Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY (for LED Type) › from 2019.09
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0406637 SIDE TURN SIGNAL LIGHT ASSEMBLY(for LED Type) A

LIGHTING (EXT)  SIDE TURN SIGNAL LIGHT ASSEMBLY(for LED Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side turn signal assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Outer rear view mirror assembly LH

·

Outer rear view mirror assembly RH


Side television camera view adjustment Panoramic view monitor system (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 87945 2.REMOVE OUTER MIRROR COVER

Hide 3.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY

a.
E358069

Remove the screw.


b.
E358070C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws to remove the door mirror foot light cover as shown in the illustration.


c.

w/ Panoramic View Monitor System:

i.

Disconnect the connector.



d.
E358071C01
0.99,1.542 1.177,1.292 false 1.219,1.156 1.458,1.354 0.24,0.198 10 false *a
*a Protective Tape


Using the screwdriver with its tip wrapped in protective tape, disengage the claw.


e.
E358072

Disengage the guides to separate the side turn signal light assembly.


f.
E358073

Disconnect the connector to remove the side turn signal light assembly.