Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
81550L
1.REMOVE REAR TURN SIGNAL LIGHT BULB
|
Remove in this Direction |
Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.
|
Remove in this Direction |
Remove the rear turn signal light bulb from the rear combination light socket and wire as shown in the illustration.
81536A
2.REMOVE REAR COMBINATION LIGHT LED (for LED Type Stop Light)
|
Remove in this Direction |
Disconnect the connector.
Remove the screw.
Turn the rear combination light LED as shown in the illustration to remove it.
3.REMOVE STOP LIGHT BULB (for Bulb Type Stop Light)
|
Remove in this Direction |
Turn the rear combination light socket and wire with the stop light bulb as shown in the illustration to disconnect them as a unit.
|
Remove in this Direction |
Remove the stop light bulb from the rear combination light socket and wire as shown in the illustration.
81550S
4.REMOVE REAR SIDE MARKER LIGHT BULB (for Bulb Type Stop Light)
|
Remove in this Direction |
Turn the rear combination light socket and wire with the rear side marker light bulb as shown in the illustration to disconnect them as a unit.
|
Remove in this Direction |
Remove the rear side marker light bulb from the rear combination light socket and wire as shown in the illustration.
81555H
5.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE (for LED Type Stop Light)
Disengage the clamp.
Disconnect the connector to remove the rear combination light socket and wire.
81555H
6.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE (for Bulb Type Stop Light)
Disengage the clamp.
Disconnect the 2 connectors to remove the rear combination light socket and wire.