Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
81134
1.INSTALL HEADLIGHT GASKET
Install a new headlight gasket.
89907
2.INSTALL HEADLIGHT ECU SUB-ASSEMBLY
for TMMT Made:
Connect the 2 connectors.
for TMC Made:
Connect the connector.
Install the connector cover to the headlight ECU sub-assembly.
Install the headlight ECU sub-assembly with the 3 screws.
If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.
3.INSTALL HEADLIGHT ASSEMBLY
4.PERFORM CALIBRATION