1.INSTALL REAR BUMPER ASSEMBLY
|
Install in the Direction |
w/ Wire Harness:
Connect the connector.
Engage the claws as shown in the illustration.
|
Install in the Direction |
Engage the claws to install the rear bumper assembly as shown in the illustration.
Use the same procedure for the RH side and LH side.
Install the 2 bolts.
Install the rear bumper upper cover LH.
Use the same procedure for the RH side and LH side.
Install the 6 clips.
Remove the protective tape.
75606B
2.INSTALL QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH
|
Install in this Direction |
Engage the clips and claws to install the quarter outside moulding sub-assembly LH as shown in the illustration.
Install the 2 screws.
Remove the protective tape.
75605B
3.INSTALL QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
52592
4.INSTALL REAR BUMPER SIDE SEAL LH
Install the rear bumper side seal LH with the 7 clips.
52591
5.INSTALL REAR BUMPER SIDE SEAL RH
Use the same procedure as for the LH side.
6.PERFORM CALIBRATION
Parking support brake system and Simple intelligent parking assist system:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION