Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>REGISTRATION
When replacing the telematics transceiver, make sure to replace it with a new one.
| *a | Component without harness connected
(Map Light Assembly (Manual (SOS) Switch)) |
Remove the map light assembly (manual (SOS) switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT (for TMMT Made)>REMOVAL
Connect 4 dry-cell batteries (1.5 V each) in series.
Check map light assembly (manual (SOS) switch) illumination.
Apply battery voltage between the terminals of the map light assembly (manual (SOS) switch) and check the illumination condition of map light assembly (manual (SOS) switch).
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → R15-7 (RRID) | Map light assembly (manual (SOS) switch) |
| Battery positive (-) → R15-1 (GND3) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F165 telematics transceiver connector.
Disconnect the R15 map light assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F165-9 (SLED) - R15-7 (RRID) | Always | Below 1 Ω |
| F165-26 (SIG-) - R15-1 (GND3) | Always | Below 1 Ω |
| F165-9 (SLED) or R15-7 (RRID) - Body ground | Always | 10 kΩ or higher |
| F165-26 (SIG-) or R15-1 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG