Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for TMMT Made) › from 2019.09
RM32K0E _54 Brake _060046 BRAKE (FRONT) _0407344 FRONT BRAKE(for TMMT Made) A

BRAKE (FRONT)  FRONT BRAKE(for TMMT Made)  REASSEMBLY  


PROCEDURE

Hide 47547B 1.TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG

a.

Temporarily install the front disc brake bleeder plug to the front disc brake cylinder assembly.

HINT:

Fully tighten the front disc brake bleeder plug after bleeding the system.



Hide 31478B 2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

a.

Install the front disc brake bleeder plug cap to the front disc brake bleeder plug.


Hide 3.INSTALL PISTON SEAL

a.
C344530C02
0,0 0,0 false
V100155

Lithium Soap Base Glycol Grease


Apply lithium soap base glycol grease to the entire circumference of a new piston seal.


b.
C365987C01
0.854,1.073 1,1.073 false 0.708,0.854 0.865,0.656 false 1,0.979 1.313,1.135 0.313,0.156 10 false *1 0.906,0.552 1.219,0.708 0.313,0.156 10 false *2
*1 Piston Seal
*2 Front Disc Brake Cylinder Assembly


Install the piston seal to the front disc brake cylinder.

NOTICE:

Securely install the piston seal into the groove of the front disc brake cylinder.



Hide 4.INSTALL FRONT DISC BRAKE PISTON

a.
C365994C01
2.167,0.583 2.417,0.583 false 2.063,1.667 2.313,1.667 false 2.458,0.5 2.771,0.656 0.313,0.156 10 false *1 2.365,1.583 2.677,1.74 0.313,0.156 10 false *2
*1 Cylinder Boot
*2 Front Disc Brake Piston
V100155

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.


b.

Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston.


c.

Install the cylinder boot to the front disc brake piston.

NOTICE:

Securely install the cylinder boot into the groove of the front disc brake piston.



d.

Install the front disc brake piston to the front disc brake cylinder assembly.

NOTICE:

Do not forcibly install the front disc brake piston into the front disc brake cylinder.



Hide 5.INSTALL CYLINDER BOOT

a.
C365988C01
0.667,0.99 0.813,0.708 false 1.594,1.625 1.865,1.313 true 0.823,0.615 1.135,0.771 0.313,0.156 10 false *1 1.292,1.542 1.698,1.698 0.406,0.156 10 false SST
*1 Cylinder Boot


Using SST and a hammer, install the cylinder boot to the front disc brake cylinder.

SST
09550-00032  

NOTICE:
·

Securely install the cylinder boot into the groove of the front disc brake cylinder assembly.

·

Do not damage the cylinder boot.