After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.
The following procedure is for the LH side.
Use the same procedure for the RH side and LH side.
04946
1.INSTALL REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
When replacing a worn rear disc brake pad, the rear disc brake anti-squeal shim kit must be replaced together with the rear disc brake pad.
| *1 | Rear Disc Brake Anti-squeal Shim |
Install the rear disc brake anti-squeal shim to each rear disc brake pad.
Install the rear disc brake anti-squeal shim in the correct positions and direction as shown in the illustration.
04466
2.INSTALL REAR DISC BRAKE PAD KIT
After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.
The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.
Push back the rear disc brake piston.
Do not forcibly install the rear disc brake piston into rear disc brake cylinder assembly.
Install the 2 rear disc brake pads to the rear disc brake cylinder mounting.
Make sure that disc brake grease is applied onto the lining surface of the rear disc brake pad.
| *a | Hold |
| *b | Turn |
Hold the rear disc brake cylinder slide pin and install the rear disc brake cylinder assembly to the rear disc brake cylinder mounting with a new bolt.
Depress the brake pedal several times.
3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
4.ADD BRAKE FLUID
5.INSTALL REAR WHEEL
6. NORMAL CONDITION RECOVERY