Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT (for TMC Made) › from 2019.09
RM32K0E _58 Vehicle Interior _062037 LIGHTING (INT) _0407921 PERSONAL LIGHT(for TMC Made) G

LIGHTING (INT)  PERSONAL LIGHT(for TMC Made)  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT MAP LIGHT ASSEMBLY

a.
E358817C01
1.302,1.729 1.615,1.323 true 0.875,1.74 1.292,1.323 true 1.885,1.719 1.667,1.104 true 2.375,1.719 1.833,1.094 true 2.833,1.719 2,1.083 true 0.115,0.063 0.427,0.219 0.313,0.156 10 false *a 0.688,1.771 1.094,1.979 0.406,0.208 10 false +B1 1.063,1.771 1.625,2 0.563,0.229 10 false DOOR 1.75,1.771 2.313,2 0.563,0.229 10 false RLMP 2.75,1.76 3.313,1.99 0.563,0.229 10 false ILLB 2.292,1.76 2.854,1.99 0.563,0.229 10 false GND
*a Component without harness connected
(Map Light Assembly)


Check the map light.

i.

Apply battery voltage to the map light assembly and check that the map light comes on.

OK:
Battery Connection Switch Condition Specified Condition
Battery positive (+) → 12 (+B1)
Battery negative (-) → 3 (GND)
Map light switch LH on Map light LH comes on
Map light switch LH off Map light LH does not come on
Map light switch RH on Map light RH comes on
Map light switch RH off Map light RH does not come on
Battery positive (+) → 12 (+B1)
Battery negative (-) → 10 (DOOR)
Map light switch off and door switch on Map light comes on
Map light switch off and door switch off Map light does not come on


If the result is not as specified, replace the map light bulb or map light assembly.



b.

Check the door switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
10 (DOOR) - 4 (RLMP) Door switch on Below 1 Ω
Door switch off 10 kΩ or higher


If the result is not as specified, replace the map light assembly.



c.

Check the switch illumination.

i.

Apply battery voltage to the map light assembly and check that the illumination comes on.

OK:
Battery Connection Specified Condition
Battery positive (+) → 2 (ILLB)
Battery negative (-) → 3 (GND)
Illumination comes on


If the result is not as specified, replace the map light assembly.