Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0304571 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P160700  Cruise Control Input Processor  


DESCRIPTION

The hybrid vehicle control ECU continuously monitors its main and sub CPUs. This self-check ensures that the hybrid vehicle control ECU is functioning properly. If outputs from the CPUs are different and deviate from the standard, the hybrid vehicle control ECU will illuminate the MIL and store the DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
P160700 Cruise Control Input Processor When prohibited by the sub-CPU, the dynamic radar cruise control system operates for 0.3 seconds or more. Hybrid vehicle control ECU

CAUTION / NOTICE / HINT

HINT:

The hybrid vehicle control ECU receives signals from each sensor to control all functions of the dynamic radar cruise control system. When a DTC is detected, the fail-safe function remains on until the power switch off.


PROCEDURE

1.CHECK FOR DTCs (CRUISE CONTROL)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 399

b.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.

1.

Turn the power switch on (IG).

2.

Turn the cruise control system on using the cruise control main switch (ON/OFF button).




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 399

Result:
Result Proceed to
DTC P160700 is not output A
DTC P160700 is output (for 2ZR-FXE) B
DTC P160700 is output (for M20A-FXS) C



A

B

C