Home › Steering › STEERING COLUMN › STEERING PAD SWITCH › 2019.09–2020.08
RM32K0E _55 Steering _061343 STEERING COLUMN _0299715 STEERING PAD SWITCH A

STEERING COLUMN  STEERING PAD SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering pad switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration
·

Lane departure alert system (w/ Steering Control)

·

Toyota parking assist-sensor system*1

·

Parking support brake system*1

·

Simple intelligent parking assist system*1

·

Pre-collision system


(Click here)
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

NOTICE:

After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 45130 1.REMOVE HORN BUTTON ASSEMBLY

Hide 84250A 2.REMOVE STEERING PAD SWITCH ASSEMBLY

a.
C365796

Disconnect connector from the spiral cable with sensor sub-assembly.


b.
C365797

Remove the 2 screws.


c.

Disengage the 4 claws and 4 pins to remove the steering pad switch assembly.