Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT BUZZER(for LHD) › 2019.09–2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0299674 DRIVING SUPPORT BUZZER(for LHD) A

CRUISE CONTROL  DRIVING SUPPORT BUZZER(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the driving support buzzer (pre-collision city buzzer) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 55545 1.REMOVE FUSE BOX OPENING COVER

Hide 86652E 2.REMOVE DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)

a.
E357139

Disengage the clamp.


b.

Disconnect the connector to remove the driving support buzzer (pre-collision city buzzer).

NOTICE:

If the driving support buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.