Home › Audio / Visual / Telematics › AUDIO / VIDEO › STEREO COMPONENT AMPLIFIER › 2019.09–2020.08
RM32K0E _56 Audio / Visual / Telematics _061817 AUDIO / VIDEO _0303530 STEREO COMPONENT AMPLIFIER A

AUDIO / VIDEO  STEREO COMPONENT AMPLIFIER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the stereo component amplifier assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)

Hide 2.REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)

Hide 86183D 3.REMOVE AUDIO AMPLIFIER COVER

a.
E353764C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Pull the audio amplifier cover in the direction indicated by the arrow (1) shown in the illustration to disengage the clips.


b.

Pull the audio amplifier cover in the direction indicated by the arrow (2) shown in the illustration to disengage the guide to remove the audio amplifier cover.


Hide 86280 4.REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET

a.
E425624

Disengage the clamp.


b.

Disconnect the 2 connectors.


c.
E426184C01
0.844,0.552 1.177,0.885 true 0.625,0.427 0.792,0.594 0.167,0.167 10 true *a
*a Lock Lever
V113147

Remove in this Direction


Disengage the claw and pull the lock lever to disconnect the connector as shown in the illustration.


d.
E426186C01
3.021,1.167 2.729,0.865 true 3.042,1.042 3.271,1.26 0.229,0.219 10 true *1
*1 Front Floor Carpet Assembly


Turn back the part of the front floor carpet assembly.


e.

Remove the 2 bolts and stereo component amplifier assembly with bracket.


Hide 86286 5.REMOVE NO. 2 AMPLIFIER BRACKET

a.
E426187

Remove the 2 screws and No. 2 amplifier bracket from the stereo component amplifier assembly.


Hide 86285 6.REMOVE NO. 1 AMPLIFIER BRACKET

a.
E426188

Remove the 2 screws and No. 1 amplifier bracket from the stereo component amplifier assembly.