Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear) › from 2019.09
RM32K0E _56 Audio / Visual / Telematics _060599 PARK ASSIST / MONITORING _0304148 ULTRASONIC SENSOR(for Rear) G

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Rear)  INSPECTION  


PROCEDURE

Hide 89342B 1.INSPECT REAR SIDE ULTRASONIC SENSOR (w/ Simple Intelligent Parking Assist System)

a.

Check the resistance.

i.
E291454C01
1.469,0.979 1.01,0.583 true 1.458,1.302 1.219,1.677 true 1.854,1.75 1.833,1.313 true 2.385,1.677 2.083,1.323 true 1.833,0.99 1.771,0.406 true 2.385,0.542 2.083,0.979 true 0.115,0.125 0.427,0.323 0.313,0.198 10 false *a 0.885,0.417 1.198,0.615 0.313,0.198 10 false EO 1.688,0.229 2,0.427 0.313,0.198 10 false SO 2.396,0.365 2.708,0.563 0.313,0.198 10 false BO 1.104,1.708 1.417,1.906 0.313,0.198 10 false EI 1.792,1.771 2.104,1.969 0.313,0.198 10 false SI 2.438,1.688 2.75,1.885 0.313,0.198 10 false BI
*a Component without harness connected
(Rear Side Ultrasonic Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (BI) - 6 (EI) Always 10 kΩ or higher
4 (BI) - 1 (BO) Always Below 1 Ω
5 (SI) - 2 (SO) Always Below 30 Ω
6 (EI) - 3 (EO) Always Below 1 Ω


If the result is not as specified, replace the rear side ultrasonic sensor.



Hide 89342 2.INSPECT REAR CORNER ULTRASONIC SENSOR

a.

Check the resistance.

i.
E388203C19
1.917,0.979 2.219,0.51 true 1.708,0.969 1.521,0.458 true 1.51,0.969 1.063,0.531 true 1.167,1.698 1.479,1.281 true 1.646,1.729 1.708,1.292 true 2.208,1.688 1.927,1.292 true 0.104,0.135 0.417,0.292 0.313,0.156 10 false *a 0.896,0.396 1.208,0.594 0.313,0.198 10 false EO 1.417,0.302 1.729,0.5 0.313,0.198 10 false SO 2.208,0.354 2.521,0.552 0.313,0.198 10 false BO 1.063,1.729 1.375,1.927 0.313,0.198 10 false EI 2.198,1.719 2.51,1.917 0.313,0.198 10 false BI 1.583,1.76 1.896,1.958 0.313,0.198 10 false SI
*a Component without harness connected (Rear Corner Ultrasonic Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (BI) - 6 (EI) Always 10 kΩ or higher
4 (BI) - 1 (BO) Always Below 1 Ω
5 (SI) - 2 (SO) Always Below 30 Ω
6 (EI) - 3 (EO) Always Below 1 Ω


If the result is not as specified, replace the rear corner ultrasonic sensor.



Hide 89342A 3.INSPECT REAR CENTER ULTRASONIC SENSOR

a.

Check the resistance.

i.
E388203C19
1.917,0.979 2.219,0.51 true 1.708,0.969 1.521,0.458 true 1.51,0.969 1.063,0.531 true 1.167,1.698 1.479,1.281 true 1.646,1.729 1.708,1.292 true 2.208,1.688 1.927,1.292 true 0.104,0.135 0.417,0.292 0.313,0.156 10 false *a 0.896,0.396 1.208,0.594 0.313,0.198 10 false EO 1.417,0.302 1.729,0.5 0.313,0.198 10 false SO 2.208,0.354 2.521,0.552 0.313,0.198 10 false BO 1.063,1.729 1.375,1.927 0.313,0.198 10 false EI 2.198,1.719 2.51,1.917 0.313,0.198 10 false BI 1.583,1.76 1.896,1.958 0.313,0.198 10 false SI
*a Component without harness connected (Rear Center Ultrasonic Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (BI) - 6 (EI) Always 10 kΩ or higher
4 (BI) - 1 (BO) Always Below 1 Ω
5 (SI) - 2 (SO) Always Below 30 Ω
6 (EI) - 3 (EO) Always Below 1 Ω


If the result is not as specified, replace the rear center ultrasonic sensor.