Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR › 2019.09–2020.08
RM32K0E _58 Vehicle Interior _062267 SUPPLEMENTAL RESTRAINT SYSTEMS _0303882 SEAT POSITION SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SEAT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat position airbag sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

NOTICE:

After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

Hide 7181B 2.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER (for Power Seat)

Hide 72277A 3.REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR

a.
B458404

for Manual Seat:

i.

Disengage the clamp.


ii.

Disconnect the connector.



b.
B458405C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Pull the seat slide position sensor protector in the direction indicated by the arrow (1), to disengage the pin, and then slide the seat slide position sensor protector in the direction indicated by the arrows (2) shown in the illustration to remove it.


Hide 89178A 4.REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat)

a.
B458406

Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor.


Hide 89178A 5.REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat)

a.
B558595

Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor with bracket.


b.
B558596

Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor from the bracket.