Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING SUPPORT BRAKE SYSTEM › from 2019.09
RM32K0E _56 Audio / Visual / Telematics _060599 PARK ASSIST / MONITORING _0408691 PARKING SUPPORT BRAKE SYSTEM W

PARK ASSIST / MONITORING  PARKING SUPPORT BRAKE SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE PARKING SUPPORT BRAKE SYSTEM


a.

Customizing with the GTS.

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the GTS to the DLC3.


ii.

Turn the power switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Body Electrical / Clearance Warning / Utility / Customize Setting.


v.

Select the setting by referring to the table below.

Clearance Warning
Tester Display Description Default Setting ECU
PKSB (O) Function Parking support brake (static objects) function ON Clearance warning ECU assembly
PKSB (O) Target Stopping Distance Parking support brake (static objects) function target stopping distance Far Clearance warning ECU assembly
PKSB Switch State Stored Sets whether to store the main switch status (ON/OFF). Stored Clearance warning ECU assembly
PKSB (V) Function Setting of the parking support brake (rear crossing traffic auto brake) function ON Clearance warning ECU assembly
50006 101