Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2019.09
RM32K0E _56 Audio / Visual / Telematics _060599 PARK ASSIST / MONITORING _0303371 TOYOTA PARKING ASSIST-SENSOR SYSTEM D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  CALIBRATION  


NOTICE:

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the TOYOTA parking assist-sensor system may not operate correctly.


ADJUST TOYOTA PARKING ASSIST-SENSOR SYSTEM


a.

w/ Parking Support Brake System

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.

Part Name Operation Adjustment Item Proceed to
Clearance warning ECU assembly Replacement Measurement of ultrasonic sensor detection angle (Click here)
Steering angle neutral point
Bumper type registration
Ultrasonic sensor detection angle registration
Ultrasonic sensor
·

Removal and installation

·

Replacement


Measurement of ultrasonic sensor detection angle
Ultrasonic sensor detection angle registration
An ultrasonic sensor becomes misaligned Measurement of ultrasonic sensor detection angle
Ultrasonic sensor detection angle registration
An ultrasonic sensor is subjected to impact Measurement of ultrasonic sensor detection angle
Ultrasonic sensor detection angle registration
Blind spot monitor sensor* Replacement Blind spot monitor beam axis confirmation (Click here)

*: w/ Blind Spot Monitor System



b.

w/o Parking Support Brake System

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.

Part Name Operation Adjustment Item Proceed to
Clearance warning ECU assembly Replacement Bumper type registration Procedure 1
Ultrasonic sensor Initialization of ultrasonic sensors
Blind spot monitor sensor* Blind spot monitor beam axis confirmation (Click here)

*: w/ Blind Spot Monitor System




REGISTRATION (PROCEDURE 1)


a.

Preparation

i.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR

NOTICE:

If DTC C1AE087, C1AE187, C1AE287, C1AE387, C1AE487, C1AE587, C1AE687, C1AE787, C1AE887, C1AE987, C1AF187, C1AF287 are output, continue with the registration procedure.




b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Clearance Warning / Utility.

Body Electrical > Clearance Warning > Utility
Tester Display
ECU Calibration
50005 438 2535

f.

According to the display on the GTS, perform calibration.


g.

w/ Parking Support Brake System

Enter the bumper type using the GTS.

Bumper Type Value
for 2ZR-FXE 1
for M20A-FXS 2

HINT:

If the clearance warning ECU assembly is replaced or removed and installed, it is necessary to perform bumper type registration.



h.

w/o Parking Support Brake System

Enter the bumper type using the GTS.

Bumper Type Value
Standard 2

HINT:

If the clearance warning ECU assembly is replaced or removed and installed, it is necessary to perform bumper type registration.