CUSTOMIZE SIMPLE INTELLIGENT PARKING ASSIST SYSTEM
Customizing with the GTS.
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the TOYOTA parking assist-sensor system on.
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Warning / Utility / Customize Setting.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Ultrasonic Sensor (Side) Alarm Function | Sets the operation range for the side sensors. | ON | $00:OFF,$01:ON | Clearance warning ECU assembly |
| Ultrasonic Sensor (Side) Alarm Detection Range | Sets the detection operation range for the side sensors. | Far | $00:Close,$01:Far | Clearance warning ECU assembly |
| IPA Obstacle Avoidance Distance | Simple intelligent parking assist obstacle avoidance distance setting | Normal | $00:Narrow,$01:Normal,$02:Wide1,$03:Wide2 | Clearance warning ECU assembly |
| IPA Perpendicular Parking Control Area | Simple intelligent parking assist perpendicular parking range setting | Normal | $00:Narrow,$01:Normal,$02:Wide1,$03:Wide2 | Clearance warning ECU assembly |
| IPA Parallel Parking Control Area | Simple intelligent parking assist parallel parking range setting | Normal | $00:Narrow,$01:Normal,$02:Wide1,$03:Wide2 | Clearance warning ECU assembly |