DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Warning / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| S-IPA Equipped Information | S-IPA Equipped Information | Without, With or Unknown | Without: w/o Simple Intelligent Parking Assist System
With: w/ Simple Intelligent Parking Assist System Unknown: Unknown |
- |
| IPA2 Equipped Information | IPA2 installation information | Without, With or Undetermined | Without: w/o intelligent parking assist system
With: w/ intelligent parking assist system Unknown: Unknown |
- |
| Ultrasonic Sensor (Front Left Side) Information | Detection range of the ultrasonic sensor | Not displayed, Obstacle Detection Close, Obstacle Detection Middle, Obstacle Detection Far, Obstacle Detection Farthest, Obstacle Detection Most Close, Temporary Malfunction, Malfunction or Normal | Not displayed: Not detected
Obstacle Detection Close: Detected (Close-range) Obstacle Detection Middle: Detected (Medium-range) Obstacle Detection Far: Detected (Long-range) Obstacle Detection Farthest: Detected (Longest-range) Obstacle Detection Most Close: Detected (Closest-range) Temporary Malfunction: Foreign matter attached to sensor resulting in temporary malfunction Malfunction: Sensor system malfunction Normal: System enabled |
- |
| Ultrasonic Sensor (Front Right Side) Information | Detection range of the ultrasonic sensor | Not displayed, Obstacle Detection Close, Obstacle Detection Middle, Obstacle Detection Far, Obstacle Detection Farthest, Obstacle Detection Most Close, Temporary Malfunction, Malfunction or Normal | Not displayed: Not detected
Obstacle Detection Close: Detected (Close-range) Obstacle Detection Middle: Detected (Medium-range) Obstacle Detection Far: Detected (Long-range) Obstacle Detection Farthest: Detected (Longest-range) Obstacle Detection Most Close: Detected (Closest-range) Temporary Malfunction: Foreign matter attached to sensor resulting in temporary malfunction Malfunction: Sensor system malfunction Normal: System enabled |
- |
| Ultrasonic Sensor (Rear Left Side) Information | Detection range of the ultrasonic sensor | Not displayed, Obstacle Detection Close, Obstacle Detection Middle, Obstacle Detection Far, Obstacle Detection Farthest, Obstacle Detection Most Close, Temporary Malfunction, Malfunction or Normal | Not displayed: Not detected
Obstacle Detection Close: Detected (Close-range) Obstacle Detection Middle: Detected (Medium-range) Obstacle Detection Far: Detected (Long-range) Obstacle Detection Farthest: Detected (Longest-range) Obstacle Detection Most Close: Detected (Closest-range) Temporary Malfunction: Foreign matter attached to sensor resulting in temporary malfunction Malfunction: Sensor system malfunction Normal: System enabled |
- |
| Ultrasonic Sensor (Rear Right Side) Information | Detection range of the ultrasonic sensor | Not displayed, Obstacle Detection Close, Obstacle Detection Middle, Obstacle Detection Far, Obstacle Detection Farthest, Obstacle Detection Most Close, Temporary Malfunction, Malfunction or Normal | Not displayed: Not detected
Obstacle Detection Close: Detected (Close-range) Obstacle Detection Middle: Detected (Medium-range) Obstacle Detection Far: Detected (Long-range) Obstacle Detection Farthest: Detected (Longest-range) Obstacle Detection Most Close: Detected (Closest-range) Temporary Malfunction: Foreign matter attached to sensor resulting in temporary malfunction Malfunction: Sensor system malfunction Normal: System enabled |
- |
| IPA Main Switch Press Status | Simple intelligent parking assist system main switch signals | OFF or ON | OFF: Simple intelligent parking assist system off
ON: Simple intelligent parking assist system on |
- |
| Ultrasonic Sensor (Side) Alarm Function | Sets the operation range for the side sensors. | Close or Far | Customized value displayed | - |
| Ultrasonic Sensor (Side) Alarm Detection Range | Sets the detection operation range for the side sensors. | Close or Far | Customized value displayed | - |
| IPA Obstacle Avoidance Distance | Simple intelligent parking assist obstacle avoidance distance setting | Narrow, Normal, Wide1 or Wide2 | Customized value displayed | - |
| IPA Perpendicular Parking Control Area | Simple intelligent parking assist perpendicular parking range setting | Narrow, Normal, Wide1 or Wide2 | Customized value displayed | - |
| IPA Parallel Parking Control Area | Simple intelligent parking assist parallel parking range setting | Narrow, Normal, Wide1 or Wide2 | Customized value displayed | - |
| Tire Circumference Setting | Tire Circumference Setting | Short3, Short2, Short1, Standard, Long1, Long2 or Long3 | Short3: Compensation amount -15 mm
Short2: Compensation amount -10 mm Short1: Compensation amount -5 mm Standard: Compensation amount 0 mm Long1: Compensation amount +5 mm Long2: Compensation amount +10 mm Long3: Compensation amount +15 mm |
- |
| Ultrasonic Sensor (Front Side) ID Not Registered | Ultrasonic Sensor (Front Side) ID Not Registered | Registered or Not Registered | Registered: ID registered
Not Registered: ID not registered |
RoB X20C2 is output if Not Registered |
| Ultrasonic Sensor (Rear Side) ID Not Registered | Ultrasonic Sensor (Rear Side) ID Not Registered | Registered or Not Registered | Registered: ID registered
Not Registered: ID not registered |
RoB X20C3 is output if Not Registered |
| Ultrasonic Sensor (Front Right Side) Temporarily Unavailable - Circuit Open | Open circuit status of the ultrasonic sensor | NO or YES | NO: No sensor open circuit
YES: Sensor open circuit |
RoB X20C4 is output if YES |
| Ultrasonic Sensor (Front Right Side) Temporarily Unavailable - Freeze/Dirt | Frozen/dirty status of the ultrasonic sensor | NO or YES | NO: Sensor not frozen/dirty
YES: Sensor frozen/dirty |
RoB X20C4 is output if YES |
| Ultrasonic Sensor (Front Right Side) Temporarily Unavailable - Foreign Material Fixing | Foreign material fixing status of the ultrasonic sensor | NO or YES | NO: Foreign matter not stuck on sensor
YES: Foreign matter stuck on sensor |
RoB X20C4 is output if YES |
| Ultrasonic Sensor (Front Right Side) Temporarily Unavailable - Parameter Malfunction | Foreign material fixing status of the ultrasonic sensor | NO or YES | NO: Foreign matter not stuck on sensor
YES: Foreign matter stuck on sensor |
RoB X20C4 is output if YES |
| Ultrasonic Sensor (Front Left Side) Temporarily Unavailable - Circuit Open | Open circuit status of the ultrasonic sensor | NO or YES | NO: Sensor not frozen/dirty
YES: Sensor frozen/dirty |
RoB X20C5 is output if YES |
| Ultrasonic Sensor (Front Left Side) Temporarily Unavailable - Freeze/Dirt | Frozen/dirty status of the ultrasonic sensor | NO or YES | NO: No sensor open circuit
YES: Sensor open circuit |
RoB X20C5 is output if YES |
| Ultrasonic Sensor (Front Left Side) Temporarily Unavailable - Foreign Material Fixing | Foreign material fixing status of the ultrasonic sensor | NO or YES | NO: Foreign matter not stuck on sensor
YES: Foreign matter stuck on sensor |
RoB X20C5 is output if YES |
| Ultrasonic Sensor (Front Left Side) Temporarily Unavailable - Parameter Malfunction | Foreign material fixing status of the ultrasonic sensor | NO or YES | NO: Foreign matter not stuck on sensor
YES: Foreign matter stuck on sensor |
RoB X20C5 is output if YES |
| Ultrasonic Sensor (Rear Right Side) Temporarily Unavailable - Circuit Open | Open circuit status of the ultrasonic sensor | NO or YES | NO: No sensor open circuit
YES: Sensor open circuit |
RoB X20C6 is output if YES |
| Ultrasonic Sensor (Rear Right Side) Temporarily Unavailable - Freeze/Dirt | Frozen/dirty status of the ultrasonic sensor | NO or YES | NO: Sensor not frozen/dirty
YES: Sensor frozen/dirty |
RoB X20C6 is output if YES |
| Ultrasonic Sensor (Rear Right Side) Temporarily Unavailable - Foreign Material Fixing | Foreign material fixing status of the ultrasonic sensor | NO or YES | NO: Foreign matter not stuck on sensor
YES: Foreign matter stuck on sensor |
RoB X20C6 is output if YES |
| Ultrasonic Sensor (Rear Right Side) Temporarily Unavailable - Parameter Malfunction | Foreign material fixing status of the ultrasonic sensor | NO or YES | NO: Foreign matter not stuck on sensor
YES: Foreign matter stuck on sensor |
RoB X20C6 is output if YES |
| Ultrasonic Sensor (Rear Left Side) Temporarily Unavailable - Circuit Open | Open circuit status of the ultrasonic sensor | NO or YES | NO: No sensor open circuit
YES: Sensor open circuit |
RoB X20C7 is output if YES |
| Ultrasonic Sensor (Rear Left Side) Temporarily Unavailable - Freeze/Dirt | Frozen/dirty status of the ultrasonic sensor | NO or YES | NO: Sensor not frozen/dirty
YES: Sensor frozen/dirty |
RoB X20C7 is output if YES |
| Ultrasonic Sensor (Rear Left Side) Temporarily Unavailable - Foreign Material Fixing | Foreign material fixing status of the ultrasonic sensor | NO or YES | NO: Foreign matter not stuck on sensor
YES: Foreign matter stuck on sensor |
RoB X20C7 is output if YES |
| Ultrasonic Sensor (Rear Left Side) Temporarily Unavailable - Parameter Malfunction | Parameter malfunction status of the ultrasonic sensor | NO or YES | NO: No sensor parameter malfunction
YES: Sensor parameter malfunction |
RoB X20C7 is output if YES |
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test by referring to the table below.
| Tester Display | Control Range | Diagnostic Note |
|---|---|---|
| Intelligent Parking Assist Indicator | S-IPA indicator light on/off | - |