If a hybrid vehicle control ECU assembly that is incompatible with the immobiliser system is installed, the hybrid vehicle control ECU assembly will store this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B279C95 | Engine Immobiliser System Incorrect Assembly | A hybrid vehicle ECU assembly that is incompatible with the immobiliser system is installed. (1-trip detection logic*) | Hybrid vehicle ECU assembly | - |
*: Only detected while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
|---|---|
| Hybrid control system cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B279C95 | - |
When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."
When replacing the hybrid vehicle control ECU assembly, refer to Service Bulletin.
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
B279C95 is not output.
| Result | Proceed to |
|---|---|
| DTC B279C95 is not output | A |
| DTC B279C95 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Replace the current hybrid vehicle control ECU assembly with a proper hybrid vehicle control ECU assembly.
for 2ZR-FXE: Click hereEngine / Hybrid System>2ZR-FXE (HYBRID / BATTERY CONTROL)>HYBRID VEHICLE CONTROL ECU>REMOVAL
for M20A-FXS: Click hereEngine / Hybrid System>M20A-FXS (HYBRID / BATTERY CONTROL)>HYBRID VEHICLE CONTROL ECU>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT