Home › Vehicle Interior › SEAT › POWER SEAT SWITCH › from 2019.09
RM32K0E _58 Vehicle Interior _061825 SEAT _0409032 POWER SEAT SWITCH G

SEAT  POWER SEAT SWITCH  INSPECTION  


PROCEDURE

Hide 84922C 1.INSPECT FRONT POWER SEAT SWITCH

a.

Check the resistance.

i.
B493076C08
0.167,0.083 3.25,3.25 3.083,3.167 0.917,0.99 0.917,1.344 true 1.208,0.99 1.208,1.344 true 1.448,0.854 1.5,0.417 true 1.813,0.854 1.917,0.417 true 1.979,1.021 2.083,0.417 true 2.125,0.833 2.333,0.427 true 2.438,1.01 2.75,0.333 true 2.635,0.865 3,0.5 true 2.146,1.25 2.25,1.417 true 2.313,1.083 2.5,1.417 true 2.635,1.24 2.833,1.5 true 2.802,1.083 3,1.25 true 1,1.917 0.938,2.344 true 1.333,1.99 1.188,2.5 true 1.5,2 1.375,2.354 true 1.729,1.99 1.521,2.51 true 2.583,2.458 2.833,2.833 true 2.25,2.458 2.5,2.833 true 2.031,2.406 2.25,2.917 true 1.698,2.406 2,3 true 1.375,2.708 1.5,3 true 1.031,2.552 1.25,3 true 0.906,2.719 0.906,2.969 true 0.75,2.552 0.583,3 true 0.167,1.667 3.25,1.667 false 0.25,0.167 0.563,0.417 0.313,0.25 12 false *A 0.25,1.74 0.583,2 0.333,0.26 12 false *B 0.417,2.99 0.729,3.146 0.313,0.156 10 false *a 1.792,1.885 2.104,2.042 0.313,0.156 10 false *b 0.938,1.708 1.25,1.865 0.313,0.156 10 false *c 0.823,3.052 1.135,3.208 0.313,0.156 10 false *d 1.458,1.76 1.771,1.917 0.313,0.156 10 false *e 1.5,3.042 1.813,3.198 0.313,0.156 10 false *f 1.854,0.188 2.146,0.458 0.292,0.271 10 false *g 1.146,1.375 1.458,1.531 0.313,0.156 10 false *i 0.865,1.365 1.208,1.646 0.344,0.281 10 false *j 0.594,3.417 0.906,3.573 0.313,0.156 10 false *k 1.271,1.76 1.583,1.917 0.313,0.156 10 false *a 2.5,1.427 2.813,1.583 0.313,0.156 10 false *a 2.042,0.208 2.354,0.365 0.313,0.156 10 false *b 2.74,0.135 3.052,0.292 0.313,0.156 10 false *b 3,0.292 3.313,0.448 0.313,0.156 10 false *c 1.208,3.052 1.521,3.208 0.313,0.156 10 false *b 2.885,1.385 3.198,1.542 0.313,0.156 10 false *d 2.323,0.219 2.635,0.375 0.313,0.156 10 false *e 2.25,1.427 2.563,1.583 0.313,0.156 10 false *f 1.99,3.042 2.281,3.313 0.292,0.271 10 false *g 2.26,2.958 2.573,3.167 0.313,0.208 10 false *h 1.479,0.229 1.792,0.438 0.313,0.208 10 false *h 2.531,2.875 2.844,3.031 0.313,0.156 10 false *i 2.854,2.865 3.198,3.146 0.344,0.281 10 false *j 3.042,1.208 3.292,1.375 0.25,0.167 10 false *a
*A for RHD
*B for LHD
*a Slide Switch (Front)
*b Slide Switch (Rear)
*c Front Vertical Switch (Up)
*d Front Vertical Switch (Down)
*e Lifter Switch (Up)
*f Lifter Switch (Down)
*g Reclining Switch (Front)
*h Reclining Switch (Rear)
*i Lumbar Support Switch (Hold)
*j Lumbar Support Switch (Release)
*k Component without harness connected
(Front Power Seat Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance (for LHD):
Slide Switch
Tester Connection Condition Specified Condition
1 - 12 Slide switch (Front) pressed Below 1 Ω
4 - 6
1 - 12 Off
4 - 12
1 - 6 Slide switch (Rear) pressed
4 - 12

Front Vertical Switch
Tester Connection Condition Specified Condition
7 - 6 Front vertical switch (Up) pressed Below 1 Ω
11 - 12
7 - 12 Off
11 - 12
7 - 12 Front vertical switch (Down) pressed
11 - 6

Lifter Switch
Tester Connection Condition Specified Condition
8 - 6 Lifter switch (Up) pressed Below 1 Ω
10 - 12
8 - 12 Off
10 - 12
8 - 12 Lifter switch (Down) pressed
10 - 6

Reclining Switch
Tester Connection Condition Specified Condition
3 - 12 Reclining switch (Front) pressed Below 1 Ω
5 - 6
6 - 7
6 - 11
3 - 12 Off
5 - 12
3 - 6 Reclining switch (Rear) pressed
5 - 12
6 - 8
6 - 10

Lumbar Support Switch
Tester Connection Condition Specified Condition
2 - 12 Lumbar switch (Hold) pressed Below 1 Ω
9 - 6
2 - 12 Off
9 - 12
2 - 6 Lumbar switch (Release) pressed
9 - 12


Standard Resistance (for RHD):
Slide Switch
Tester Connection Condition Specified Condition
2 - 12 Slide switch (Front) pressed Below 1 Ω
5 - 6
2 - 6 Off
5 - 6
2 - 6 Slide switch (Rear) pressed
5 - 12

Front Vertical Switch
Tester Connection Condition Specified Condition
7 - 6 Front vertical switch (Up) pressed Below 1 Ω
11 - 12
7 - 6 Off
11 - 6
7 - 12 Front vertical switch (Down) pressed
11 - 6

Lifter Switch
Tester Connection Condition Specified Condition
8 - 6 Lifter switch (Up) pressed Below 1 Ω
10 - 12
8 - 6 Off
10 - 6
8 - 12 Lifter switch (Down) pressed
10 - 6

Reclining Switch
Tester Connection Condition Specified Condition
1 - 12 Reclining switch (Front) pressed Below 1 Ω
3 - 6
7 - 12
11 - 12
1 - 6 Off
3 - 6
1 - 6 Reclining switch (Rear) pressed
3 - 12
8 - 12
10 - 12

Lumbar Support Switch
Tester Connection Condition Specified Condition
4 - 6 Lumbar switch (Hold) pressed Below 1 Ω
9 - 12
4 - 6 Off
9 - 6
4 - 12 Lumbar switch (Release) pressed
9 - 6


If the result is not as specified, replace the front power seat switch.