The radio and display receiver assembly receives a reverse signal from the BKUP LP relay.
Move the shift lever to R and check if the back-up lights come on.
The back-up lights come on.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/ Headlight ECU) | B |
| NG (w/o Headlight ECU) | C |
A
B
C
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
Disconnect the F129 radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F129-28 (REV) - Body ground | Power switch on (IG)
Shift lever in R |
11 to 14 V |
| F129-28 (REV) - Body ground | Power switch on (IG)
Shift lever not in R |
Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG