Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) › from 2019.09
RM32K0E _56 Audio / Visual / Telematics _061817 AUDIO / VIDEO _0301273 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Illumination Circuit  


DESCRIPTION

Power is supplied to the radio receiver assembly and steering pad switch assembly illumination when the light control switch is in the tail or head position.

WIRING DIAGRAM

E391864E05
2.073,0.573 3.219,0.792 1.146,0.219 10 false from TAIL Relay 3.885,0.771 4.656,0.969 0.771,0.198 10 false PANEL 5.917,0.583 6.333,0.823 0.417,0.24 10 false ILL+ 5.625,0.479 5.875,0.719 0.25,0.24 10 false 10 5.688,1.167 5.938,1.406 0.25,0.24 10 false 7 5.917,1.302 6.396,1.542 0.479,0.24 10 false GND1 5.354,1.615 5.74,1.833 0.385,0.219 10 false F48 5.365,1.802 6.99,2.042 1.625,0.24 10 false Radio Receiver Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.CHECK ILLUMINATION
a.

Check if the illumination for the radio receiver assembly, steering pad switch assembly, heater control switch or others (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the head or tail position.

Result:
Result Proceed to
Illumination comes on for all components except radio receiver assembly. A
No illumination comes on (radio receiver assembly, hazard switch, heater control switch, etc.). B




A

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)

B

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.

Disconnect the radio receiver assembly connector.


b.
E360341C01
1.479,0.427 1.927,0.667 0.448,0.24 2.333,1.667 2.167,1.323 true 2.344,1.698 2.958,1.896 0.615,0.198 10 false ILL+ 1.573,0.469 2.031,0.667 0.458,0.198 10 false F48 0.104,0.115 0.563,0.313 0.458,0.198 10 false *a
*a Front view of wire harness connector
(to Radio Receiver Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F48-10 (ILL+) - Body ground Light control switch in tail or head position 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR