This DTC is stored if the parking assist ECU judges as a result of its self check that the vehicle information received via CAN communication and the vehicle information stored in the parking assist ECU do not match.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C168D | Vehicle Information Unmatched | Vehicle information unmatched | ·
Camera view adjustment (calibration) ·
Steering angle setting ·
Parking assist ECU |
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.
Refer to camera view adjustment (calibration).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Refer to steering angle setting.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
DTC C168D is not output.
If DTC C168D is output, perform the procedure to allow the parking assist ECU to store the vehicle information again.
If DTC C168D is still output after performing the procedure to make the parking assist ECU store the vehicle information 3 times, replace the parking assist ECU.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Circumference Monitoring Camera Control Module / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Back Camera Availability Consistency | Status of ECU stored in rear television camera assembly | OK/NG | OK: Normal
NG: Rear television camera assembly or parking assist ECU is abnormal |
- |
| Side Camera LH Availability Consistency | Status of ECU stored in side television camera assembly LH | OK/NG | OK: Normal
NG: Side television camera assembly LH or parking assist ECU is abnormal |
- |
| Front Camera Availability Consistency | Status of ECU stored in front television camera assembly | OK/NG | OK: Normal
NG: Front television camera assembly or parking assist ECU is abnormal |
- |
| Side Camera RH Availability Consistency | Status of ECU stored side television camera assembly RH | OK/NG | OK: Normal
NG: Side television camera assembly RH or parking assist ECU is abnormal |
- |
| Tester Display |
|---|
| Back Camera Availability Consistency |
| Side Camera LH Availability Consistency |
| Front Camera Availability Consistency |
| Side Camera RH Availability Consistency |
| Result | Proceed to |
|---|---|
| "NG" is displayed for any of the following items:
·
Back Camera Availability Consistency ·
Side Camera LH Availability Consistency ·
Front Camera Availability Consistency ·
Side Camera RH Availability Consistency |
A |
| "OK" is displayed for all items. | B |
A
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
B