Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › from 2019.09
RM32K0E _56 Audio / Visual / Telematics _060599 PARK ASSIST / MONITORING _0410446 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C1694  Steering Angle Initialization Incomplete  


DESCRIPTION

This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC No. Detection Item DTC Detection Condition Trouble Area
C1694 Steering Angle Initialization Incomplete Maximum steering angle has not been memorized
·

Steering angle setting

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.PERFORM SETTINGS (STEERING ANGLE SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.



Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
50002 353

b.

Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
50001 353
HINT:
·

If DTC C1694 is output, perform the steering angle setting again.

·

If DTC C1694 is still output after performing the steering angle setting 3 times, replace the parking assist ECU.




Result:
Result Proceed to
No DTCs are output A
DTC C1694 is output B



A

END (SETTINGS ARE DEFECTIVE)

B