Home › Engine / Hybrid System › 2ZR-FXE (EMISSION CONTROL) › CANISTER › from 2018.05
RM32K0E _51 Engine / Hybrid System _060064 2ZR-FXE EMISSION CONTROL _0294229 CANISTER G

2ZR-FXE EMISSION CONTROL  CANISTER  INSPECTION  


PROCEDURE

Hide 1.CHECK CANISTER (FUEL SUCTION PLATE SUB-ASSEMBLY)

a.

Visually check the canister (fuel suction plate sub-assembly).

i.

Visually check the canister (fuel suction plate sub-assembly) for cracks or damage.

If cracks or damage are found, replace the canister (fuel suction plate sub-assembly).



b.

Inspect the ventilation of the canister (fuel suction plate sub-assembly).

i.
A435293C01
1.26,0.354 1.5,0.354 1.5,0.354 1.625,0.625 false 2.156,1.125 2.656,1.125 true 2.688,1.042 2.854,1.24 0.167,0.198 10 true *a 1.104,0.26 1.417,0.5 0.313,0.24 10 false *b 2.76,1.74 3.063,1.99 0.302,0.25 10 false *c
*a Port (A)
*b Port (B)
*c Air


Apply compressed air to the port (A) and check that the air flows out from the port (B).

OK:

The air flows from the port (B).



ii.
A379120C01
1.292,0.156 1.49,0.156 1.49,0.156 1.688,0.479 false 2.271,0.969 2.854,0.969 true 2.906,0.875 3.167,1.063 0.26,0.188 10 false *a 1.052,0.083 1.375,0.302 0.323,0.219 10 false *b 2.542,0.146 2.885,0.427 0.344,0.281 10 false *c
*a Port (A)
*b Port (B)
*c Air


Close the port (A), apply compressed air to the port (B).

OK:

Air does not flow at first. By gradually increasing the pressure, air flows when the pressure in the port reaches a certain level.



iii.
A379121C01
2.302,2.302 2.76,2.302 true 1.521,0.26 1.979,0.26 false 1.427,1.417 1.573,1.417 1.573,1.417 1.646,1.781 false 2.813,2.208 3.104,2.438 0.292,0.229 10 false *a 1.208,1.333 1.427,1.51 0.219,0.177 10 false *b 2.031,0.167 2.365,0.417 0.333,0.25 10 false *c
*a Port (A)
*b Port (B)
*c Vacuum Pump


Using a vacuum pump, apply vacuum to the port (B) with the port (A) closed.

OK:

The vacuum is maintained at first. By gradually increasing the vacuum, air flows and the vacuum decreases after the vacuum reaches a certain level.