This circuit includes the navigation ECU and radio and display receiver assembly.
Disconnect the n1*1 or F167*2 radio and display receiver assembly connector.
Disconnect the n2*1 or F168*2 navigation ECU connector.
Measure the resistance according to the value(s) in the table below.
*1: for TMMT Made
*2: for TMC Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| n1-28 (REV2) - n2-19 (REV2) | Always | Below 1 Ω |
| n1-28 (REV2) or n2-19 (REV2) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F167-28 (REV2) - F168-19 (REV2) | Always | Below 1 Ω |
| F167-28 (REV2) or F168-19 (REV2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG