Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2019.09–2022.01
RM32K0E _56 Audio / Visual / Telematics _061290 NAVIGATION / MULTI INFO DISPLAY _0302427 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU  


DESCRIPTION

This circuit includes the navigation ECU and radio and display receiver assembly.

WIRING DIAGRAM

E367997E61
1.385,0.906 1.99,1.177 0.604,0.271 10 false SUP 1.76,0.781 2.365,1.052 0.604,0.271 10 false 21 5.313,0.781 5.917,1.052 0.604,0.271 10 false 7 0.771,1.781 2.604,2.042 1.833,0.26 10 false n2*1, F168*2 0.771,1.938 1.833,2.229 1.063,0.292 10 false Navigation ECU 5.5,1.781 6.688,2.021 1.188,0.24 10 false n1*1, F167*2 5.5,1.948 6.74,2.313 1.24,0.365 10 false Radio and Display Receiver Assembly 5.573,0.885 6.177,1.156 0.604,0.271 10 false SUP 1.979,2.375 3.844,2.792 1.865,0.417 10 false *1: for TMMT made 3.615,2.375 5.479,2.792 1.865,0.417 10 false *2: for TMC made

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the n1*1 or F167*2 radio and display receiver assembly connector.


b.

Disconnect the n2*1 or F168*2 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

*1: for TMMT Made

*2: for TMC Made


Standard Resistance:
for TMMT Made
Tester Connection Condition Specified Condition
n1-7 (SUP) - n2-21 (SUP) Always Below 1 Ω
n1-7 (SUP) or n2-21 (SUP) - Body ground Always 10 kΩ or higher

for TMC Made
Tester Connection Condition Specified Condition
F167-7 (SUP) - F168-21 (SUP) Always Below 1 Ω
F167-7 (SUP) or F168-21 (SUP) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR