Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2019.09
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0304282 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.
B459697C15
1.448,0.24 1.958,0.49 0.51,0.25 1.385,1.208 0.99,1.76 true 1.969,1.198 1.656,1.719 true 2.177,1.198 2.417,1.74 true 0.177,0.146 0.49,0.302 0.313,0.156 10 false *a 1.583,0.292 1.896,0.448 0.313,0.156 10 false A91 0.729,1.771 1.146,1.969 0.417,0.198 10 false GND 1.604,1.75 1.917,1.906 0.313,0.156 10 false B 2.417,1.75 2.729,1.906 0.313,0.156 10 false B
*a Front View of Wire Harness Connector
(to Stop Light Switch Assembly)


Disconnect the A91 stop light switch assembly connector.


b.

Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A91-7 (B) - A91-2 (GND) Power switch off 11 to 14 V
A91-6 (B) - A91-2 (GND) Power switch on 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
A91-2 (GND) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the wire harness or connector.


c.
C401043C63
1.417,0.083 1.938,0.333 0.521,0.25 2.042,1.063 2.521,1.625 true 2.198,0.938 2.583,0.833 true 1.885,1.063 2.063,1.625 true 1.708,1.052 1.333,1.667 true 0.865,0.521 1.531,0.938 true 0.188,0.115 0.417,0.281 0.229,0.167 10 false *a 1.563,0.135 2.01,0.396 0.448,0.26 10 false A91 2.646,0.74 3.094,0.958 0.448,0.219 10 false OUT 2.073,1.656 2.385,1.865 0.313,0.208 10 false L 2.563,1.615 3.063,1.833 0.5,0.219 10 false GND 1.104,1.688 1.552,1.948 0.448,0.26 10 false ACC 0.708,0.396 1.021,0.604 0.313,0.208 10 false L
*a Component with Harness Connected
(Stop Light Switch Assembly)


Reconnect the A91 stop light switch assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A91- 1 (OUT) - A91-2 (GND) Power switch off, brake pedal not depressed Below 1 V
A91-1 (OUT) - A91-2 (GND) Power switch off, brake pedal depressed 11 to 14 V
A91-3 (L) - A91-2 (GND) Power switch off, brake pedal not depressed Below 1 V
A91-3 (L) - A91-2 (GND) Power switch off, brake pedal depressed 11 to 14 V
A91-4 (ACC) - A91-2 (GND) Power switch off 11 to 14 V
A91-5 (L) - A91-2 (GND) Power switch on, brake pedal not depressed 11 to 14 V
A91-5 (L) - A91-2 (GND) Power switch on, brake pedal depressed Below 1 V


If the result is not as specified, replace the stop light switch assembly.