The combination meter assembly receives the hazard warning signal switch assembly on signal and controls the operation of the hazard warning lights.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Connect the GTS to the DLC3.
Turn the power switch to on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Hazard Flasher Switch | Hazard warning signal switch signal | ON or OFF | ON: Hazard warning signal switch on
OFF: Hazard warning signal switch off |
- |
| Tester Display |
|---|
| Hazard Flasher Switch |
Normal conditions listed above are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the hazard warning signal switch assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>HAZARD WARNING SWITCH>REMOVAL
Inspect the hazard warning signal switch assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>HAZARD WARNING SWITCH>INSPECTION
Hazard warning signal switch assembly is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F5 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F62-4 (TB) - F5-3 (HAZ) | Always | Below 1 Ω |
| F62-4 (TB) or F5-3 (HAZ) - Body ground | Always | 10 kΩ or higher |
| F62-1 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG