Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › 2019.09–2020.08
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0299231 AUTOMATIC HIGH BEAM SYSTEM T

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.

·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform Forward Recognition Camera Learning.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)



HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Automatic High Beam System
Symptom Suspected Area Link
Automatic high beam system does not operate or automatic high beam indicator does not illuminate (low beam headlights and high beam headlights are normal) Check automatic high beam indicator light Click here
Check Data List (Auto H Beam STS0)
Check Active Test (Automatic High Beam Indicator)
Check automatic high beam main switch
Harness or connector