Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2019.09
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0303092 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM C

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  B2452  Height Control Sensor Data Out of Range When Initializing  


DESCRIPTION

The headlight ECU sub-assembly LH stores this DTC if the sensor value received from the rear height control sensor sub-assembly LH is out of range when performing initialization of the headlight ECU sub-assembly LH; for example, the vehicle is not level or being jack up.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2452 Height Control Sensor Data Out of Range When Initializing Rear height control sensor sub-assembly LH value is out of range when initializing
·

Vehicle condition when initializing

·

Rear height control sensor sub-assembly LH


-

CAUTION / NOTICE / HINT

NOTICE:

If any of the following are performed, it is necessary to initialize the headlight ECU sub-assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION

·

Replacement of the rear height control sensor sub-assembly LH

·

Removal/installation of the rear height control sensor sub-assembly LH

·

Work that changes the vehicle height such as replacement of suspension components



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR

Body Electrical > AFS > Clear DTCs
50002 165

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Turn the power switch to on (IG).


b.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR

Body Electrical > AFS > Trouble Codes
50001 165
OK:

DTC B2452 is not output.



Result:
Proceed to
OK
NG



OK

NG

3.CHECK AND REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
3.CHECK AND REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
a.

Check the installation condition of the rear height control sensor sub-assembly LH.

OK:

Rear height control sensor sub-assembly LH is installed correctly.



Result:
Proceed to
OK
NG



OK

REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

NG