When the main body ECU (multiplex network body ECU) receives the light control switch position signal, it sends an illumination request signal to the DRL relay and illuminates the clearance lights.
When the operation conditions of the daytime running lights are met, the main body ECU (multiplex network body ECU) sends an illumination request signal to the DRL relay and illuminates the daytime running lights.
Inspect the fuses for circuits related to this system before performing the following procedure.
w/ Entry and Start System:
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Check the operation of the clearance lights.
The clearance lights operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/o Headlight ECU)>PROBLEM SYMPTOMS TABLE
Connect the GTS to the DLC3.
Turn the power switch to on (IG).
Enter the following menus: Body Electrical / Main Body / Active Test.
| Tester Display |
|---|
| Daytime Running Light |
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Daytime Running Light | Daytime running lights | ON or OFF | - |
Daytime running lights illuminate.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/o Headlight ECU)>PROBLEM SYMPTOMS TABLE
NG
Disconnect the A88 headlight unit assembly LH connector.
Disconnect the A89 headlight unit assembly RH connector.
Disconnect the 3F instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A88-4 (B) - 3F-28 | Always | Below 1 Ω |
| A89-4 (B) - 3F-28 | Always | Below 1 Ω |
| A88-4 (B) or 3F-28 - Body ground | Always | 10 kΩ or higher |
| A89-4 (B) or 3F-28 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Remove the instrument panel junction block assembly.
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3F-28 - MB-25 (DRL) | Always | Below 1 Ω |
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG (for LHD) | C |
| NG (for RHD) | D |
A
B
C
D