Home › Engine / Hybrid System › 2ZR-FXE (FUEL) › FUEL PRESSURE REGULATOR › from 2020.08
RM32K0E _51 Engine / Hybrid System _060063 2ZR-FXE FUEL _0294217 FUEL PRESSURE REGULATOR A

2ZR-FXE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure regulator assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

NOTICE:
A398082C04
0.625,1.51 0.958,1.51 false 0.396,1.406 0.708,1.604 0.313,0.198 10 false *a
*a Tube


Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.


HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1
Toyota parking assist-sensor system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 23280J 2.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.
A338498

Remove the No. 3 fuel suction support from the fuel suction tube with pump and gauge assembly.


b.
A432189C03
0.49,0.427 0.698,0.427 0.698,0.427 1.292,0.729 true 0.281,0.375 0.698,0.813 0.417,0.438 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, remove the fuel pressure regulator assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Pull out the fuel pressure regulator assembly carefully because the O-rings are firmly installed between the fuel pressure regulator assembly and the fuel suction tube with pump and gauge assembly.



c.
A148186C12
1.583,0.646 1.583,0.427 1.583,0.427 0.625,0.427 false 0.927,1.396 0.927,0.427 false 0.427,0.344 0.604,0.479 0.177,0.135 10 *1
*1 O-ring


Remove the 2 O-rings from the fuel pressure regulator assembly.