Home › Engine / Hybrid System › 2ZR-FXE (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2020.08
RM32K0E _51 Engine / Hybrid System _060064 2ZR-FXE EMISSION CONTROL _0438654 DIFFERENTIAL PRESSURE SENSOR G

2ZR-FXE EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89481B 1.INSPECT DIFFERENTIAL PRESSURE SENSOR

a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / GPF Differential Pressure Sensor Bank1.

Powertrain > Engine > Data List
Tester Display
GPF Differential Pressure Sensor Bank 1
50003 372 571

e.

Slide the clip and disconnect the vacuum transmitting hose assembly from the differential pressure sensor.


f.
A459028N01
2.042,1.052 2.188,0.792 2.188,0.792 2.438,0.792 true 2.552,0.708 2.885,0.917 0.333,0.208 10 true SST

Connect SST to the differential pressure sensor.

SST
09992-00242  


g.

Using SST, apply pressure to the differential pressure sensor.


h.

Check the pressure value of the differential pressure sensor.

Standard:
GTS Display Condition Specified Condition
GPF Differential Pressure Sensor Bank 1 Power switch on (IG) When applying 20 kPa (2.9 psi): 20 kPa (2.9 psi)
When applying 40 kPa (5.8 psi): 40 kPa (5.8 psi)


NOTICE:

Perform the inspection within the range of 0 to 98 kPa (0 to 14.2 psi).


If the result is not as specified, replace the differential pressure sensor.


i.

Disconnect SST from the differential pressure sensor.


j.

Connect the vacuum transmitting hose assembly to the differential pressure sensor and slide the clip to secure it.