16595B
1.INSTALL NO. 1 RADIATOR AIR GUIDE LH
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guide and claw to install the No. 1 radiator air guide LH as shown in the illustration.
16593B
2.INSTALL NO. 1 RADIATOR AIR GUIDE RH
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guide and claw to install the No. 1 radiator air guide RH as shown in the illustration.
52134G
3.INSTALL FRONT BUMPER BRACKET LH
Install the front bumper bracket LH with the 4 bolts.
52133F
4.INSTALL FRONT BUMPER BRACKET RH
Use the same procedure as for the LH side.
52132A
5.INSTALL NO. 2 FRONT BUMPER REINFORCEMENT
Install the No. 2 front bumper reinforcement with the 2 nuts.
57014A
6.INSTALL FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY LH
| *a | Clamp |
| *b | Guide |
Engage the guides to install the front side member bracket sub-assembly LH.
Install the 4 bolts.
Engage the clamp.
57013C
7.INSTALL FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY RH
Engage the guides to install the front side member bracket sub-assembly RH.
Install the 4 bolts.
52131A
8.INSTALL FRONT BUMPER REINFORCEMENT
Engage the guides to install the front bumper reinforcement.
Install the 6 bolts.
Engage the wire harness clamps.
52618
9.INSTALL LOWER FRONT BUMPER ABSORBER
|
Install in this Direction |
Engage the guides to install the lower front bumper absorber as shown in the illustration.
52611
10.INSTALL FRONT BUMPER ENERGY ABSORBER
|
Install in this Direction |
Engage the guides to install the front bumper energy absorber as shown in the illustration.
16561C
11.INSTALL NO. 1 RADIATOR TO SUPPORT SEAL
|
Install in this Direction |
Install the No. 1 radiator to support seal as shown in the illustration.
Install the 2 clips.
Engage the wire harness clamp.
53117C
12.INSTALL NO. 1 RADIATOR GRILLE RETAINER
|
Install in this Direction |
Engage the claws to install the No. 1 radiator grille retainer as shown in the illustration.
52536
13.INSTALL FRONT BUMPER SIDE RETAINER LH
|
Install in this Direction |
Engage the claw to install the front bumper side retainer LH as shown in the illustration.
| *a | Bolt |
| *b | Screw |
Install the screw.
Install the bolt.
52535
14.INSTALL FRONT BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
52116A
15.INSTALL FRONT BUMPER SIDE SUPPORT LH
Install the grommet.
Clean the front bumper lower cover surface.
Remove the double-sided tape from the front bumper lower cover.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from a new front bumper side support LH.
After removing the release paper, keep the exposed adhesive free from foreign matter.
|
Double-sided Tape |
Engage the guides to install the front bumper side support LH.
Install the screw.
Press the double-sided tape area of the front bumper side support LH.
52115A
16.INSTALL FRONT BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
53121H
17.INSTALL NO. 1 RADIATOR GRILLE MOULDING
Engage the guides to install the No. 1 radiator grille moulding.
Install the 14 clips and 3 screws.
53127B
18.INSTALL NO. 7 RADIATOR GRILLE MOULDING
Engage the hook and claws to install the No. 7 radiator grille moulding.
53125D
19.INSTALL NO. 5 RADIATOR GRILLE MOULDING
|
Install in this Direction |
Engage the claw to install the No. 5 radiator grille moulding as shown in the illustration.
Install the screw.
75310A
20.INSTALL RADIATOR GRILLE EMBLEM ASSEMBLY
52129B
21.INSTALL FRONT BUMPER LOWER COVER
Install the 6 grommets.
Engage the guides and claws to install the front bumper lower cover.
Install the 2 clips and 4 outside moulding retainers.
52146C
22.INSTALL FRONT BUMPER SIDE STAY LH
Engage the claws to install the front fender liner retainer.
Engage the claws to install the front bumper side stay LH.
Install the screw and clip.
52145H
23.INSTALL FRONT BUMPER SIDE STAY RH
Use the same procedure as for the LH side.
53102A
24.INSTALL LOWER RADIATOR GRILLE SUB-ASSEMBLY
Install the 2 nuts.
Engage the guides and claws to install the lower radiator grille sub-assembly.
Install the 4 screws.
52676A
25.INSTALL NO. 1 FRONT BUMPER SIDE SUPPORT LH
Engage the claw to install the No. 1 front bumper side support LH.
Install the screw.
52675B
26.INSTALL NO. 1 FRONT BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
52128B
27.INSTALL FRONT BUMPER HOLE COVER LH
Engage the claws to install the front bumper hole cover LH.
Install the screw.
52127D
28.INSTALL FRONT BUMPER HOLE COVER RH
Use the same procedure as for the LH side.
82119C
29.INSTALL NO. 5 ENGINE ROOM WIRE
Engage the clamps to install the No. 5 engine room wire.
81220
30.INSTALL FOG LIGHT ASSEMBLY LH
81210A
31.INSTALL FOG LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
53111
32.INSTALL RADIATOR GRILLE