86461
1.INSTALL FORWARD RECOGNITION HOOD
|
Inner Surface of Forward Recognition Hood |
Do not touch the inner surface of the forward recognition hood.
Do not apply force to the heating element of the forward recognition hood or an open circuit may result.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
|
Herter Area |
Engage the guides and claws as indicated by the arrows, in the order shown in the illustration to install the forward recognition hood.
Make sure that the claws are engaged as shown in the illustration. Failure to do so may result in the malfunction of systems that use the forward recognition camera.
Do not apply force to the heating element of the forward recognition hood or an open circuit may result.
| *a | Clamp |
| *b | Guide |
Engage the clamp and guides to install the wire harness to the forward recognition bracket.
As the No. 1 forward recognition cover cannot be installed correctly if the clamp and guides are not engaged securely, make sure to engage each clamp and guide securely.
Engage the clamp and ribs in the order shown in the illustration.
Connect the connector.
8646C
2.INSTALL FORWARD RECOGNITION CAMERA