If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
88211B
1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
If the front bumper assembly or radiator grill has been replaced, check that the beam axis change mechanism is at the standard position (centered).
|
Bolt |
|
Screw |
Engage the guides.
Install the millimeter wave radar sensor assembly with the 2 bolts and screw.
Tighten the bolts in the order shown in the illustration.
88215
2.INSTALL NO. 1 MILLIMETER WAVE RADAR SENSOR BRACKET
Engage the guide.
Install the No. 1 millimeter wave radar sensor bracket with the 2 bolts.
3.INSTALL FRONT BUMPER ASSEMBLY
except GR SPORT:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except GR SPORT)>INSTALLATION
for GR SPORT:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for GR SPORT)>INSTALLATION
4.ADJUST MILLIMETER WAVE RADAR SENSOR
When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Millimeter wave radar sensor assembly Learning can be performed by using either Triangle Target or Flat Surface Target or Driving Adjustment.
Triangle Target:
Flat Surface Target:
Driving Adjustment:
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>DRIVING ADJUSTMENT