Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH › from 2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0299671 CRUISE CONTROL MAIN SWITCH A

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cruise control main switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1
Toyota parking assist-sensor system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 45130 1.REMOVE HORN BUTTON ASSEMBLY

Hide 45186 2.REMOVE LOWER NO. 2 STEERING WHEEL COVER

a.
C362092C01
1.583,1.302 1.583,0.969 true 1.521,1.333 1.75,1.49 0.229,0.156 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws and guide to remove the lower No. 2 steering wheel cover.


Hide 84632 3.REMOVE CRUISE CONTROL MAIN SWITCH

a.
C362093C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Remove the 2 screws.


c.

Remove the cruise control main switch as shown in the illustration.


Hide 84633 4.REMOVE CRUISE CONTROL SWITCH WIRE

a.
C362094

Disconnect the connector to remove the cruise control switch wire from the cruise control main switch.