Home › Engine / Hybrid System › CRUISE CONTROL › FRONT CAMERA SYSTEM › from 2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0440928 FRONT CAMERA SYSTEM U

CRUISE CONTROL  FRONT CAMERA SYSTEM  TERMINALS OF ECU  


CHECK FORWARD RECOGNITION CAMERA


NOTICE:
·

DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

·

Do not apply excessive force to the forward recognition camera connector.



A417823E63
2.063,0.75 2.458,1.01 0.396,0.26 2.167,0.802 2.625,1 0.458,0.198 10 false R5

a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
R5-7 (IGB) - R5-10 (GND) B - W-B Power source Power switch on (IG) 11 to 14 V
Power switch off Below 1 V
R5-8 (BZ) - R5-10 (GND) P - W-B*1
B - W-B*2
Pre-collision city buzzer output Power switch on (IG) buzzer not sounding 11 to 14 V
Power switch on (IG) buzzer sounding Below 1 V
R5-1 (HTR) - R5-10 (GND) BE - W-B Forward recognition hood operation signal Power switch on (IG)
Forward recognition hood not operating
11 to 14 V
Power switch on (IG)
Forward recognition hood operating
Below 1 V
R5-10 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

*1: for TMC Made

*2: for TMMT Made