Home › Engine / Hybrid System › CRUISE CONTROL › FRONT CAMERA SYSTEM › from 2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0440928 FRONT CAMERA SYSTEM D

CRUISE CONTROL  FRONT CAMERA SYSTEM  FREEZE FRAME DATA  


DESCRIPTION


a.

When a front camera system DTC is stored, the forward recognition camera stores the current vehicle (ECU or sensor) state as Freeze Frame Data.



CHECK FREEZE FRAME DATA


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.

Chassis > Front Recognition Camera > Trouble Codes
50001 430

e.

According to the display on the GTS, select a DTC with freeze frame data.


f.

Read the freeze frame data recorded when the DTC was stored.



FREEZE FRAME DATA CHART


Chassis > Front Recognition Camera
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Total Distance Traveled - - - Cannot be used
Total Distance Traveled - Unit - - - Cannot be used
Vehicle Information (Steering Wheel Position) Vehicle information (steering wheel position) stored in forward recognition camera Unknown / Left / Right Actual steering wheel position displayed If the value of this item differs from the specifications of the vehicle, a forward recognition camera which was installed to another vehicle may be installed or the forward recognition camera may be malfunctioning.
HV/EV Equipped Information Vehicle information (powertrain type) stored in forward recognition camera Non-HV/EV / HV/EV Non-HV/EV: Conventional vehicle
HV/EV: Hybrid vehicle
If the value of this item differs from the specifications of the vehicle, a forward recognition camera which was installed to another vehicle may be installed or the forward recognition camera may be malfunctioning.
Buzzer (Line) Equipped Information Existence of forward recognition camera buzzer Absent / Present Absent: Not equipped
Present: Equipped
If the value of this item differs from the specifications of the vehicle, a forward recognition camera which was installed to another vehicle may be installed or the forward recognition camera may be malfunctioning.
IG Status Information - - - Cannot be used
Occurrence Times of Front Recognition Camera Optical Axis Misalignment - - - Cannot be used
Weather Condition (Heavy Fog) Existence of weather condition (heavy fog) Not Detected / Detected Not Detected: Has not been detected
Detected: Weather condition (heavy fog) detected
-
Weather Condition (Heavy Snow / Heavy Rain) Existence of weather condition (heavy snow/heavy rain) Not Detected / Detected Not Detected: Has not been detected
Detected: Weather condition (heavy snow/heavy rain) detected
-
Vehicle Speed Speed of the vehicle 0 to 255 km/h 0 km/h: Vehicle is stopped -
Front Recognition Camera Low Voltage Existence of forward recognition camera low voltage malfunction Not Low Voltage / Low Voltage Not Low Voltage If the value of this item is "Low Voltage", the front camera system may have been temporarily unavailable.
Front Recognition Camera High Voltage Existence of forward recognition camera high voltage malfunction Not High Voltage / High Voltage Not High Voltage If the value of this item is "High Voltage", the front camera system may have been temporarily unavailable.
Front Recognition Camera Low Temperature Existence of forward recognition camera low temperature malfunction Not Low Temperature / Low Temperature Not Low Temperature: Approximately -30°C (-22°F) or more
Low Temperature: Less than approximately -30°C (-22°F)
·

If the value of this item is "Low Temperature", the front camera system may have been temporarily unavailable.

·

If this item is "Low Temperature", X2016 is output in the vehicle control history


Front Recognition Camera High Temperature 1 Existence of forward recognition camera high temperature malfunction Not High Temperature / High Temperature Not High Temperature: Less than approximately 80°C (176°F)
High Temperature: Approximately 80°C (176°F) or more
·

If this item is "High Temperature", the camera will be temporarily unavailable. If this does not improve even if the inside of the vehicle is left cooled for at least 10 minutes, the forward recognition camera may be malfunctioning.

·

If this item is "High Temperature", X2016 is output in the vehicle control history.


HINT:

In summertime, the windshield glass may reach 100°C (212°F) or higher


Front Recognition Camera Optical Axis Misalignment (X) Existence of forward recognition camera optical axis misalignment (horizontal) Not Axis Misalignment / Axis Misalignment Not Axis Misalignment If the value of this item is "Axis Misalignment", the forward recognition camera optical axis may have become misaligned. Check if the forward recognition camera optical axis is misaligned.
Front Recognition Camera Optical Axis Misalignment (Y) Existence of forward recognition camera optical axis misalignment (vertical) Not Axis Misalignment / Axis Misalignment Not Axis Misalignment If the value of this item is "Axis Misalignment", the forward recognition camera optical axis may have become misaligned. Check if the forward recognition camera optical axis is misaligned.
Front Recognition Camera Roll Angle Optical Axis Misalignment Existence of forward recognition camera optical axis misalignment (roll) Not Axis Misalignment / Axis Misalignment Not Axis Misalignment If the value of this item is "Axis Misalignment", the forward recognition camera optical axis may have become misaligned. Check if the forward recognition camera optical axis is misaligned.
Heater Available Information Existence of forward recognition hood Absence / Presence Absence: w/o forward recognition hood
Presence: w/ forward recognition hood
The forward recognition camera checks its electrical connectivity with the heater wire. If this item is "Absence", a new forward recognition camera may have been installed with the heater wire disconnected.
Heater Control Permit Forward recognition hood control permission Not Allow / Allow Not Allow: Forward recognition hood control prohibited
Allow: Forward recognition hood control activated
If this item is "Prohibited", the following conditions are possible:
·

There is no heater wire.

·

The forward recognition camera has stored a DTC.

·

The forward recognition camera has stored vehicle control history.


Heater Control Forward recognition hood control state Not Control / Under Control Not Control: Forward recognition hood control not performed
Under Control: Forward recognition hood control being performed
If the heater wire control permission item is "Permitted" and the ambient temperature is 10°C (50°F) or less, this item will cycle between "Not Control" and "Under Control".