CHECK FORWARD RECOGNITION CAMERA
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.
Do not apply excessive force to the forward recognition camera connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| R5-7 (IGB) - R5-10 (GND) | B - W-B | Power source | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V | |||
| R5-3 (LKSW) - R5-10 (GND) | SB - W-B*1
R - W-B*2 |
Steering pad switch signal
(LTA main switch signal) |
Power switch off
LTA main switch off |
1 MΩ or higher |
| Power switch off
LTA main switch on |
228 to 252 Ω | |||
| R5-10 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
*1: for TMC Made
*2: for TMMT Made