CUSTOMIZE PRE-COLLISION SYSTEM
When the customer requests a change in a function, first make sure that the function can be customized.
Make a note of the current settings before customizing.
Customizing with the Multi-information Display
The following PCS functions and the pre-collision system sensitivity setting can be changed from their default setting.
Turn the power switch on (IG).
Change pre-collision system settings by operating steering pad switch.
Pre-collision system settings are shown in the Settings tab of the multi-information display.
| Display | Description | Setting | Default |
|---|---|---|---|
| PCS | Turns the pre-collision system function ON/OFF. | ON/OFF | ON |
| Sensitivity | Sets the pre-collision system function warning sensitivity | Early/Mid/Late | Mid |
Customizing with the GTS
The following customization settings allow retention of applicable operation settings for the PCS operation state and PCS warning sensitivity distance to be turned ON or OFF.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Customize Setting / Others.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| PCS Function ON/OFF State Stored | Refer to the table below | Not Stored | $00:Not Stored,$01:Stored | Millimeter wave radar sensor assembly |
| PCS Warning Timing State Stored 1 | Refer to the table below | Not Stored | $00:Not Stored,$01:Stored | Millimeter wave radar sensor assembly |
| PCS Warning Timing State Stored 2 | Refer to the table below | Stored | $00:Not Stored,$01:Stored | Millimeter wave radar sensor assembly |
| PCS Warning Timing State Stored 3 | Refer to the table below | Not Stored | $00:Not Stored,$01:Stored | Millimeter wave radar sensor assembly |
| Customize Setting | Description | Setting |
|---|---|---|
| PCS Function ON/OFF State Stored | When the PCS function is OFF and the power switch is turned to off and then on (IG), this setting controls whether the prior PCS ON/OFF setting is retained. | Not Stored: PCS function resets to ON
Stored: PCS function remains OFF |
| PCS Warning Timing State Stored 1 | When the power switch is on (IG) and the PCS function is turned from off to ON, this setting controls whether the prior PCS warning sensitivity setting is retained. | Stored: Warning sensitivity is maintained at the previous value
Not Stored: Warning sensitivity resets to "Mid" |
| PCS Warning Timing State Stored 2 | When the PCS function is ON and the power switch is turned to off and then on (IG), this setting controls whether the prior PCS warning sensitivity setting is retained. | Stored: Warning sensitivity is maintained at the previous value
Not Stored: Warning sensitivity resets to "Mid" |
| PCS Warning Timing State Stored 3 | When the PCS function is OFF and the power switch is turned to off and then on (IG), this setting controls whether the prior PCS warning sensitivity setting is retained. | Stored: Warning sensitivity is maintained at the previous value
Not Stored: Warning sensitivity resets to "Mid" |