FUNCTION OF WARNING INDICATOR AND MESSAGE
If the pre-collision system is not functioning properly, the driver is warned by the PCS warning light and a warning message is displayed on the multi-information display.
| Warning Message | Detail | DTC/RoB | PCS warning light |
|---|---|---|---|
| "Pre-Collision System Malfunction Visit Your Dealer" | Pre-collision system malfunctioning | Stored | Illuminates |
| "Pre-Collision System Radar In Self Calibration Unavailable See Owner's Manual" | Millimeter wave radar sensor assembly misaligned | Stored | Illuminates |
| "Pre-Collision System Out of Temperature Range Unavailable See Owner's Manual" | Millimeter wave radar sensor assembly temperature malfunction | Stored | Illuminates |
| "Pre-Collision System Unavailable See Owner's Manual" | ·
Millimeter wave radar sensor assembly voltage malfunction ·
Determination was made for temporary suspension of system operation due to millimeter wave radar sensor assembly detecting interference from other nearby radar emitters |
Stored | Illuminates |
| "Pre-Collision System Radar Sensor Blocked Unavailable Clean Radar Sensor" | Foreign matter attached to millimeter wave radar sensor assembly | Stored | Illuminates |
| "Front Camera Unavailable See Owner's Manual" | Abnormal forward recognition camera voltage | Stored | Illuminates |
| "Front Camera Out of Temperature Range Unavailable Wait until Normal Temperature" | Forward recognition camera temperature outside of operational range | Stored | Illuminates |
| "Front Camera Low Visibility Unavailable See Owner's Manual" | ·
Foreign matter attached to forward recognition camera or area of windshield in front of forward recognition camera ·
Forward recognition camera or area of windshield in front of forward recognition camera is fogged up |
Stored | Illuminates |
| "VSC Turned Off Pre-Collision Brake System Unavailable" | VSC system is disabled | Not stored | Illuminates |
| PCS Warning Light | Condition |
|---|---|
| Illuminates | Pre-collision system malfunctioning |
| Pre-collision system temporarily disabled | |
| During pre-collision system radar alignment | |
| Pre-collision system disabled | |
| VSC system disabled | |
| Not illuminated | Other |
INITIAL CHECK
An initial check is performed when the power switch is off for more than 2 seconds and then turned ON. The initial check consists of a pre-collision system diagnostic check with a duration of approximately 3 seconds.
If a malfunction is discovered during initial check, then after the initial check (after 3 seconds have elapsed), the PCS warning light in the combination meter assembly will illuminate and a message indicating a pre-collision system malfunction or that the pre-collision system is temporarily unusable will be displayed in the multi-information display.
CONSTANT CHECK
The millimeter wave radar sensor assembly constantly monitors the pre-collision system for malfunctions after the power switch is turned on (IG) and the initial check (approximately 3 seconds) has completed.
If a malfunction is detected during the constant check, the PCS warning light in the combination meter assembly will illuminate and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.