DESCRIPTION
When a pre-collision system DTC is stored, the millimeter wave radar sensor assembly stores the current vehicle state as Freeze Frame Data.
CHECK FREEZE FRAME DATA
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Pre-Collision System / Trouble Codes.
According to the display on the GTS, select a DTC to display its freeze frame data.
Read the freeze frame data recorded when the DTC was stored.
FREEZE FRAME DATA CHART
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | - | - | - | Cannot be used |
| Total Distance Traveled - Unit | - | - | - | Cannot be used |
| PCS Function ON/OFF State | Status of the pre-collision system OFF switch | ON / OFF | ON: Pre-collision system enabled
OFF: Pre-collision system disabled |
- |
| PBA Request | Pre-collision brake assist operation status (While a control command is present, assist control operates when the driver depresses the brake pedal.) | Not PBA Request / PBA Standby Request / PBA Request Level 1 / PBA Request Level 2 | Not PBA Request: Pre-collision brake assist not requested
PBA Standby Request: Low pre-collision brake assist requested PBA Request Level 1: Medium pre-collision brake assist requested PBA Request Level 2: High pre-collision brake assist requested |
The value changes in accordance with the possibility of a collision. This item indicates the pre-collision brake assist standby status. Whether pre-collision brake assist is applied or not is determined by the depression of the brake pedal. |
| VGRS Activation Request | VGRS control activation start | Not Request / VGRS 1 Request / VGRS 2 Request / VGRS 3 Request | Not Request:
VGRS 1 Request: Request 1 VGRS 2 Request: Request 2 VGRS 3 Request: Request 3 |
This item is displayed on the GTS for vehicles without the VGRS system, but cannot be used |
| Warning Brake Request | Warning brake operational status | ON / OFF | ON: Operating
OFF: Not operating |
- |
| FPB Request | Skid control ECU (brake booster with master cylinder assembly) PCS brake request (pre-braking) | ON / OFF | ON: Operating
OFF: Not operating |
- |
| PB Request | Pre-collision brake request status | ON / OFF | ON: Operating
OFF: Not operating |
- |
| AVS Control Request | AVS control activation status | ON / OFF | ON: AVS control activated
OFF: AVS control not activated |
This item is displayed on the GTS for vehicles without AVS, but cannot be used |
| Prefill | Skid control ECU (brake booster with master cylinder assembly) PCS brake assist standby | ON / OFF | ON: Operating
OFF: Not operating |
- |
| PBR Request | PBR operation status | ON / OFF | ON: Operating
OFF: Not operating |
- |
| PBH Request | PBH operation status | ON / OFF | ON: Operating
OFF: Not operating |
- |
| LPB Request | LPB operation status | ON / OFF | ON: Operating
OFF: Not operating |
- |
| PCS PBA Invalid | Pre-collision brake assist function status | ON / OFF | ON: Pre-collision brake assist function invalid
OFF: Pre-collision brake assist function valid |
- |
| PCS Warning Buzzer Invalid | PCS warning buzzer status | ON / OFF | ON: PCS warning buzzer function invalid
OFF: PCS warning buzzer function valid |
- |
| PCS PB Invalid | PCS brake function status | ON / OFF | ON: PCS brake function invalid
OFF: PCS brake function valid |
- |
| Acceleration Suppression at Low Speed (A Control) Invalid | Acceleration suppression at low speed (A control) invalid status | ON / OFF | ON: Acceleration suppression at low speed (A control) function invalid
OFF: Acceleration suppression at low speed (A control) function valid |
Cannot be used |
| Emergency Steering Assist Invalid 1 | Emergency Steering Assist Invalid 1 status | ON / OFF | ON: Emergency steering assist invalid 1 function invalid
OFF: Emergency steering assist invalid 1 function valid |
w/ Emergency steering assist |
| Emergency Steering Assist Invalid 2 | Emergency Steering Assist Invalid 2 status | ON / OFF | ON: Emergency steering assist invalid 2 function invalid
OFF: Emergency steering assist invalid 2 function valid |
w/ Emergency steering assist |
| PCS Warning Display Request | PCS warning message status | Not Request / PCS Warning Display 1 Request / PCS Warning Display 2 Request / PCS Warning Display 3 Request | Not Request: Not displayed
PCS Warning Display 1 Request: Displayed PCS Warning Display 2 Request: Not used PCS Warning Display 3 Request: Not used |
"BRAKE!" is displayed on multi-information display |
| PCS Warning Buzzer Request | Pre-collision city buzzer operation status | ON / OFF | ON: Sounding
OFF: Not sounding |
- |
| PCS Function ON/OFF State Stored | Pre-collision system on/off setting when the pre-collision system is turned off and the power switch is turned off and then to on (IG). | Stored / Not Stored | Stored: PCS function remains OFF
Not Stored: PCS function resets to ON |
"PCS Function ON/OFF State Stored" is a customizable item which can be set using the GTS. |
| PCS Warning Timing State Stored 2 | Sensitivity setting when the pre-collision system is turned on and the power switch is turned off and then to on (IG). | Stored / Not Stored | Stored: Warning sensitivity is maintained at the previous value
Not Stored: Warning sensitivity resets to "Mid" |
"PCS Warning Timing State Stored 2" is a customizable item which can be set using the GTS. |
| PCS Warning Timing State Stored 3 | Sensitivity setting when the pre-collision system is turned off and the power switch is turned off and then to on (IG). | Stored / Not Stored | Stored: Warning sensitivity is maintained at the previous value
Not Stored: Warning sensitivity resets to "Mid" |
"PCS Warning Timing State Stored 3" is a customizable item which can be set using the GTS. |
| PCS Warning Timing State Stored 1 | Sensitivity setting of the pre-collision system when the pre-collision system is turned off and the then on with the power switch on (IG). | Stored / Not Stored | Stored: Warning sensitivity is maintained at the previous value
Not Stored: Warning sensitivity resets to "Mid" |
"PCS Warning Timing State Stored 1" is a customizable item which can be set using the GTS. |