Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM32K0E _58 Vehicle Interior _061839 PRE-COLLISION _0303861 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  C142571  Stop Light Relay Actuator Stuck  


DESCRIPTION

The stop light switch and skid control ECU (brake booster with master cylinder assembly) output stop light signals. If the skid control ECU (brake booster with master cylinder assembly) detects a malfunction in circuits related to the stop light, it informs the millimeter wave radar sensor assembly via CAN communication, and DTC C142571 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C142571 Stop Light Relay Actuator Stuck When the power switch is on (IG) for 3 seconds or more, a stop light circuit malfunction signal is received from the skid control ECU (brake booster with master cylinder assembly) for 1 second or more. Electronically controlled brake system

PROCEDURE

1.INSPECT ELECTRONICALLY CONTROLLED BRAKE SYSTEM
HINT:

If DTC C142571 is output by the pre-collision system, perform troubleshooting for the electronically controlled brake system.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING


Result:
Proceed to
NEXT



NEXT

END