Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM32K0E _58 Vehicle Interior _061839 PRE-COLLISION _0303861 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U012587  Lost Communication with Multi-axis Acceleration Sensor Module Missing Message  U012687  Lost Communication with Steering Angle Sensor Module Missing Message  U012987  Lost Communication with Brake System Control Module Missing Message  U015587  Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message  U029387  Lost Communication with Hybrid/EV Powertrain Control Module Missing Message  


DESCRIPTION

The following DTCs are stored when there is a communication malfunction between the millimeter wave radar sensor and each sensor or ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area
U012587 Lost Communication with Multi-axis Acceleration Sensor Module Missing Message When the power switch is on (IG) for 3 seconds or more, at a vehicle speed of 5 km/h (3 mph) or more, a communication malfunction with the yaw rate sensor (airbag sensor assembly) continues for approximately 1 second or more. CAN communication system
U012687 Lost Communication with Steering Angle Sensor Module Missing Message When the power switch is on (IG) for 3 seconds or more, a steering sensor communication malfunction continues for approximately 1 second or more. CAN communication system
U012987 Lost Communication with Brake System Control Module Missing Message When the power switch is on (IG) for 3 seconds or more, a communication error between the skid control ECU (brake booster with master cylinder assembly) and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. CAN communication system
U015587 Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message When the power switch is on (IG) for 3 seconds or more, a combination meter assembly communication malfunction continues for 8 seconds or more. CAN communication system
U029387 Lost Communication with Hybrid/EV Powertrain Control Module Missing Message When the power switch is on (IG) for 3 seconds or more, a communication malfunction with the hybrid vehicle control ECU continues for approximately 3 seconds or more. CAN communication system

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Pre-Collision System > Clear DTCs
50002 432

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTCs
2.CHECK FOR DTCs
a.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



b.

Check for DTCs.

Body Electrical > Pre-Collision System > Trouble Codes
50001 432

Result:
Result Proceed to
DTC U012587, U012687, U012987, U015587 and U029387 are not output A
DTC U012587, U012687, U012987, U015587 or U029387 is output B



A

B