The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear engine oil seal removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
30900
1.REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
31270
2.REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY
Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.
Using height adjustment attachments and plate lift attachments, keep the engine assembly level.
To prevent the oil pan sub-assembly from deforming, do not place any attachments under the oil pan sub-assembly of the engine assembly.
Using an engine sling device and engine lift, secure the engine assembly before servicing.
Using SST, hold the crankshaft pulley assembly.
Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.
13405
3.REMOVE FLYWHEEL SUB-ASSEMBLY
Using SST, hold the crankshaft pulley assembly.
Remove the 8 bolts and flywheel sub-assembly from the crankshaft.
19315
4.REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE
Remove the No. 1 crankshaft position sensor plate.
11401L
5.REMOVE REAR ENGINE OIL SEAL
| *a | Protective Tape |
| *b | Cut Position |
Using a knife, cut off the lip of the rear engine oil seal.
Using a screwdriver, pry out the rear engine oil seal.
Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.
Tape the screwdriver tip before use.