Home › General › MAINTENANCE › 2ZR-FXE AUXILIARY BATTERY › from 2020.08
RM32K0E _V1 General _059911 MAINTENANCE _0295427 2ZR-FXE AUXILIARY BATTERY A

MAINTENANCE  2ZR-FXE AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the auxiliary battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1
Toyota parking assist-sensor system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions with a capacity of 51 Ah or more at a 20-hour rate.



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A387986

Loosen the nut and disconnect the cable from the negative (-) auxiliary battery terminal.


Hide 3.REMOVE AUXILIARY BATTERY

a.

Disengage the 2 claws and open the battery terminal cap in the order shown in the illustration.

A387473C02
0.917,0.146 1.229,0.344 0.313,0.198 10 false *a 0.823,2.156 0.979,2.354 0.156,0.198 10 true 1 2.042,1.281 2.198,1.479 0.156,0.198 10 true 1 5.625,1.865 5.781,2.063 0.156,0.198 10 true 2
*a Top View of Claws - -
V113146

Push Battery Terminal Cap Here
V113147

Push
V113148

Open - -



b.
A387349

Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.


c.
A394390

Remove the battery insulator from the auxiliary battery.


d.
A387988

Remove the bolt and battery clamp No. 2.


e.
A394391

Remove the auxiliary battery from the vehicle.