The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front disc brake pad removal/installation are shown below.
When removing or installing the front disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C1214 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this step.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISABLE BRAKE CONTROL
3.REMOVE FRONT WHEEL
4.REMOVE FRONT DISC BRAKE PAD
After lifting up the front disc brake cylinder assembly, secure it in place before performing any work on it.
The front disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.
| *a | Turn |
| *b | Hold |
Hold the front disc brake cylinder slide pin (lower side) and remove the bolt.
Do not kink or damage the brake line.
Pull the front disc brake cylinder assembly upward.
Remove the 2 front disc brake pads from the front disc brake cylinder mounting.
04945
5.REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT
Remove the front disc brake anti-squeal shim from each front disc brake pad.
Remove the 2 front brake pad radial springs from each front disc brake pad.