Home › Engine / Hybrid System › 2ZR-FXE (HYBRID / BATTERY CONTROL) › HV BATTERY (for LITHIUM-ION BATTERY) › from 2020.08
RM32K0E _51 Engine / Hybrid System _083958 2ZR-FXE HYBRID / BATTERY CONTROL _0404392 HV BATTERY(for LITHIUM-ION BATTERY) N

2ZR-FXE HYBRID / BATTERY CONTROL  HV BATTERY(for LITHIUM-ION BATTERY)  DISCHARGING  


PROCEDURE

Hide 1. DISCHARGING (WHEN USING THE LI-ION BATTERY DISCHARGER)

CAUTION:

Be sure to wear insulated gloves and protective goggles.


NOTICE:
Make sure to observe the following points when using the Li-ion battery discharger.
·

Set it in a secure, flat place.

·

Set it in a dry place protected from dust and water.

·

Set it in a position where illumination of the LED indicators can be observed.

·

Do not block the ventilation holes or cooling fans.



a.

Select Li-ion battery connection cables

i.
A378139

Confirm the type of the Li-ion battery connection cable as indicated by the tag shown in the illustration. (Type: TM4216-41)



b.

Install Li-ion battery connection cable

i.
N101004

Set the Li-ion battery discharger as shown in the illustration.


ii.
N101005C04
3.042,0.938 2.5,0.938 true 3.094,0.885 3.344,1.146 0.25,0.26 10 false *a
*a Connector (A)


Connect the Li-ion battery connection cable connector (A) to the Li-ion battery discharger connector (A).

NOTICE:

Make sure that the connector is connected securely.



iii.
N101006C04
1.594,1.479 2.177,1.479 false 2.25,1.417 2.51,1.604 0.26,0.188 10 false *a
*a Connector (B)


Connect the Li-ion battery connection cable connector (B) to the Li-ion battery discharger connector (B).

NOTICE:

Make sure that the connector is connected securely.



iv.
N101020

Set the Li-ion battery discharger as shown in the illustration.

HINT:

The Li-ion battery discharger is set on its side so that the ventilation holes will not be blocked.




c.

Connect Li-ion battery connection cable

i.
A376377

Move the lock lever while pushing the lock, and disconnect the 4 high-voltage connectors (orange) from the battery ECU assembly.


ii.
A376378

Connect the Li-ion battery connection cable connectors (orange) to the 4 high-voltage connectors (orange) of the HV battery.


iii.
A378144

Confirm that all of the LED indicators are illuminated as shown in the following table.

CAUTION:

If all of the LED indicators of the Li-ion battery discharger listed in the following table are not illuminated, the HV battery cannot be discharged using the Li-ion battery discharger. Make sure to soak the HV battery in a salt water solution to complete discharging.


LED Indicator Illumination Status (When discharge has started normally)
LED Indicator No. LED Indicator Illumination Status LED Indicator No. LED Indicator Illumination Status LED Indicator No. LED Indicator Illumination Status
1 Illuminated 2 Illuminated 3 Illuminated
4 Illuminated 5 Illuminated 6 Illuminated
7 Illuminated 8 Illuminated 9 Illuminated
10 Illuminated 11 Illuminated 12 Illuminated
13 Illuminated 14 Illuminated 15 Illuminated
16 Illuminated 17 Illuminated 18 Illuminated
19 Illuminated 20 Illuminated 21 Illuminated
22 Illuminated 23 Illuminated 24 Illuminated
25 Illuminated 26 Illuminated 27 Illuminated
28 Illuminated 29 Illuminated 30 Illuminated
31 Illuminated 32 Illuminated 33 Illuminated
34 Illuminated 35 Illuminated 36 Illuminated
37 Illuminated 38 Illuminated 39 Illuminated
40 Illuminated 41 Illuminated 42 Illuminated
43 Illuminated 44 Illuminated 45 Illuminated
46 Illuminated 47 Illuminated 48 Illuminated
49 Illuminated 50 Illuminated 51 Illuminated
52 Illuminated 53 Illuminated 54 Illuminated
55 Illuminated 56 Illuminated 57 Not illuminated
58 Not illuminated 59 Not illuminated 60 Not illuminated
61 Not illuminated 62 Not illuminated 63 Not illuminated
64 Not illuminated 65 Not illuminated 66 Not illuminated
67 Not illuminated 68 Not illuminated 69 Not illuminated
70 Not illuminated 71 Not illuminated 72 Not illuminated
73 Not illuminated 74 Not illuminated 75 Not illuminated


iv.

Confirm that the cooling fans operate.

N101026C04
2.417,0.385 3.042,0.385 true 4.021,0.385 4.552,0.385 true 3.073,0.281 3.385,0.479 0.313,0.198 10 false *a 3.844,0.281 4.156,0.479 0.313,0.198 10 false *a
*a Cooling Fans - -


HINT:
·

To discharge the HV battery completely, continue discharging for at least 1 hour after the LED indicators have turned off.

·

Discharge of a fully charged HV battery will complete within 5 hours (including 1 hour waiting time after the LED indicators have turned off).





d.

Confirm discharge completion

i.

Confirm that all of the LED indicators of the Li-ion battery discharger have turned off.


ii.

Continue to discharge the battery for 1 hour after all of the LED indicators of the Li-ion battery discharger have turned off.



e.

Disconnect Li-ion battery connection cable

i.
A376372

Disconnect the Li-ion battery connection cable connector (orange) from the 4 high-voltage connectors (orange) of the HV battery.



f.

Remove Li-ion battery connection cable

i.
N101024

Set the Li-ion battery discharger as shown in the illustration.


ii.
N101012C04
1.604,1.51 2.125,1.51 false 2.167,1.448 2.698,1.677 0.531,0.229 10 false *a
*a Connector (B)


Disconnect the Li-ion battery connection cable connector (B) from the Li-ion battery discharger connector (B).


iii.
N101013C04
2.531,0.844 3.063,0.844 false 3.115,0.76 3.427,1.031 0.313,0.271 10 false *a
*a Connector (A)


Disconnect the Li-ion battery connection cable connector (A) from the Li-ion battery discharger connector (A).



Hide 2. DISCHARGING (WHEN USING THE SALT WATER SOLUTION)

CAUTION:

Be sure to wear insulated gloves and protective goggles.


NOTICE:
·

When discharging using salt water solution, first add a measured amount of water to the container, and then add the concentrated salt water solution.

·

Calculate the salt water concentration based on the measured volume of water in the container so that a 1% salt water solution will be made after adding the concentrated salt water solution to the water in the container where HV battery is set.



a.

Prepare HV battery

i.
A376366C01
2.417,2.927 2.792,2.49 2.792,2.49 2.031,1.594 false 2.896,2.406 3.208,2.604 0.313,0.198 10 false *b 0.135,0.052 0.448,0.25 0.313,0.198 10 false *a
*a Example
*b Container (A)


Set the HV battery in the container (A).



b.

Prepare to discharge (Add water to container)

i.
A294871C01
1.771,0.698 1.979,0.344 1.979,0.344 2.208,0.344 false 0.073,0.083 0.385,0.281 0.313,0.198 10 false *a 2.26,0.26 2.573,0.458 0.313,0.198 10 false *b
*a Example
*b Container (B)


Measure the water capacity of the container (B).

HINT:

Water capacity of the container (B) is assumed as X (liter).



ii.
A376367C01
1.083,0.958 1.302,0.958 1.302,0.958 1.333,1.146 false 1.104,3.49 1.323,3.49 1.323,3.49 1.354,3.677 false 1.01,0.573 1.229,0.573 1.229,0.573 1.26,0.76 false 1,3.146 1.219,3.146 1.219,3.146 1.25,3.333 false 2.323,0.385 2.615,0.385 false 2.344,2.875 2.635,2.875 false 0.073,0.052 0.385,0.25 0.313,0.198 10 false *a 0.917,0.865 1.219,1.063 0.302,0.198 10 false *b 0.844,0.479 1.156,0.677 0.313,0.198 10 false *c 0.823,3.063 1.135,3.26 0.313,0.198 10 false *c 2.167,2.792 2.479,2.99 0.313,0.198 10 false *d 2.677,0.302 2.99,0.5 0.313,0.198 10 false *d 0.938,3.406 1.24,3.604 0.302,0.198 10 false *b
*a Example
*b Water Surface
*c Container (A)
*d Container (B)


Using the container (B), add water to the container (A) until the HV battery is completely submerged.

NOTICE:

Make sure to record the times the container (B) was filled with water to add water to the container (A).



iii.

Using the following formula, calculate the amount of water added to the container (A).

Amount of water added to the container (A):

Y (liter) = Water capacity of the container (B) x Number of times the container (B) was filled with water to submerge the HV battery


HINT:

Amount of water added to the container (A) is assumed as Y (liter).




c.

Prepare salt water solution

i.
A294873C01
1.667,0.698 1.813,0.417 1.813,0.417 2.063,0.417 false 0.094,0.115 0.406,0.313 0.313,0.198 10 false *a 2.125,0.344 2.438,0.542 0.313,0.198 10 false *b
*a Example
*b Container (B)


While measuring the amount of water, fill about half of the container (B) with water.

HINT:

Amount of water added to the container (B) is assumed as Z (liter).



ii.

Calculate the amount of salt to be added to the container (A) so that a 1% salt water solution will be made.

Amount of Salt:

Amount of salt (kg) = (Y (liter) + Z (liter)) x 0.01



iii.
A294872C01
1.688,0.688 1.76,0.427 1.76,0.427 1.948,0.427 false 0.073,0.063 0.385,0.26 0.313,0.198 10 false *a 2.021,0.344 2.333,0.542 0.313,0.198 10 false *b
*a Example
*b Container (B)


Add the calculated amount of salt to the container (B) and stir it thoroughly.



d.

Add salt water solution

i.
A289001

Add the concentrated salt water solution to the container (A).



e.

Discharge

i.

Leave the HV battery as is for 24 hours or more until discharge is complete.

CAUTION:
·

Do not place a lid on the container.

·

Make sure to leave the HV battery and container as is for 24 hours or more.

·

Display a warning sign to inform others that discharge is being performed.





f.

Confirm discharge completion

i.

Check that bubbles are not forming in the container.

NOTICE:

If bubbles are forming, discharge may not be completed yet. Do not place a lid on the container.




g.

Display a warning sign such as "DO NOT TOUCH! (DISCHARGE BEING PERFORMED) to inform others. Make a copy of the warning sign and place it near the HV battery being discharged.

A289826